User manual DRAKE DIGITAL DAD860

[. . . ] DAD860 and DAD860A Digital to Analog Decoders Instruction Manual DAD860 LOCK LINK RS232 PROGRAM TM is a registered trademark of R. Drake LLC P/N: 3852492-D-2010 © Copyright 2010 R. L. Drake LLC 2 Caution Statements WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE TO RAIN OR MOISTURE A product and cart combination should be moved with care. Quick stops, excessive force and uneven surfaces may cause the product and cart combination to overturn. [. . . ] NOTE: The information presented on pages 8, 9, and 10 applies to the DAD860 and DAD860A even though the references will only mention DAD860. The UNIT button on the DAD860 Controller is used to select the unit to be programmed. The actual programming is done via the UP, DOWN, LEFT, RIGHT and ENTER buttons. The chart below shows each of the menus that are available for parameter value setup and/or viewing for the DAD860 being programmed. Pressing the LEFT or RIGHT arrow buttons will navigate through these menus. You may do this without danger of disturbing any of the current settings when not in program mode. As you navigate through the menus the parameter name is listed on the top line of the display and the current value is shown on the bottom line. For setup purposes, it is best to progress clockwise through the chart (use the right arrow button), starting from the default UNIT # screen. In the chart below shows the values that are available in each of these menus. DAD860 CONTROLLER MENU FLOW CHART SYSTEM BOOT UP DRAKE DAD860 UNIT # SN xx dB USE LIST Current Channel CH PLAN OFF AIR CATV STD CATV HRC CATV IRC RF LIST USE LIST MAN SEL SCAN ADD SCAN NEW CLR LIST MAN SEL Select Mode MPEG PGM AUD PID Select CH # Select CH # Select MPEG # Select Audio PID # RF # MPEG # SCAN ADD Select Channel Scanning ADD SCAN NEW CONFIRM? Scanning NEW CLR LIST NO MUTE VERSION NUMBER CONFIRM? CLEARING MUTE SCR BLUE SCR NO VID WEAK SIG NO MUTE MUTE AUDIO 1. FRE VOLUME 0 - 100 MODE STRETCH LTR BOX CROPPED AFD/ LTR. AFD/CROP TV TYPE 4:3 16:9 DAD860 Setup and Programming (cont. ) RF LIST SECONDARY MENUS A DAD860 can store in its memory a list of all of the digital channels and the MPEG programs they contain, which it can receive from the CATV or offair signal source to which it is connected. The values shown for the RF LIST parameter each lead to secondary menus that allow manipulation of this stored channel and MPEG information. The following is a description of each of these secondary menu functions. These secondary menus can only be accessed when in the program mode. USE LIST - This function allows selection of the desired channel and MPEG program from a channels LIST previously stored the DAD860's memory. From the "RF LIST" parameter screen USE LIST is the default value. "USE LIST" and the currently stored channel number will be displayed. This will take the operator to "RF # - MPEG # " screen where the desired channel and MPEG numbers can be selected from the stored list using the UP and DOWN arrow buttons. Press the RIGHT arrow button again to save the value and proceed to the next parameter in the primary menu. MAN SEL - This function allows storage of a particular RF channel and MPEG program value whether or not signals are being received. It is also used to select a specific audio PID if that is desired. [. . . ] DRAKE will make note of any shipping damage upon receipt. You will need to send proof of purchase to receive warranty service. Typically, a copy of the invoice from an R. L. The warranty is for the original owner only and is not transferable. 14 Warranty Three Year Limited Warranty R. L. [. . . ]