User manual DRAYTEK VIGOR 3300V PLUS V1.1

[. . . ] ii Vigor3300V+ Series User's Guide Vigor3300 V+ Multi-WAN Security Router User's Guide Version: 1. 1 Firmware Version: V2. 6. 3 Date: 23/08/2010 Vigor3300V+ Series User's Guide iii Copyright Information Copyright Declarations Copyright 2010 All rights reserved. This publication contains information that is protected by copyright. No part may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language without written permission from the copyright holders. The following trademarks are used in this document: Microsoft is a registered trademark of Microsoft Corp. [. . . ] After finishing the configuration, please click this button to invoke these settings. Apply 4. 2. 7 Limit Session A PC with private IP address can access to the Internet via NAT router. The router will generate the records of NAT sessions for such connection. The P2P (Peer to Peer) applications (e. g. , BitTorrent) always need many sessions for procession and they will occupy over resources which might result in important accesses impacted. To solve the problem, you can use limit session to limit the session procession for specified Hosts. General Setup This function allows users to configure general settings for limit session. Click Network >>Limit Session and then choose General Setup. You will get the following page. Enable/Disable Default Session Limit Apply Disables or enables this function. Defines the default session number used for each computer in LAN. After finishing the configuration, please click this button to invoke these settings. Limitation Table This function allows users to set limitation for limit session. Click Network >>Limit Session and then choose Limitation Table. You will get the following page. 126 Vigor3300V+ Series User's Guide Start IP End IP Session Number Edit Delete/Delete All Display the start IP address. Click this button to open the edit page for adjusting the settings. Click this button to delete the selected setting or all settings. Click OK to delete this entry from the Load Balance Policy table. In addition, click Delete All in the Load Balance Policy page to delete all of 10 entries on this page. To edit an entry, select it by clicking the radio button (from 1 to 10). Then click the Edit button on the bottom to bring up the following Web page. Start IP End IP Session Number Assign the start IP address for limit session. Assign the end IP address for limit session. Assign the available session number for each host in the specific range of IP addresses. If you do not set the session number in this field, the system will use the default session limit for the specific limitation you set for each index. After finishing the configuration, please click this button to invoke these settings. Apply Vigor3300V+ Series User's Guide 127 4. 3 Advanced Setup In the Advanced menu, there are several items offered here for you to adjust for the router. 4. 3. 1 Static Route Setup When you have several subnets in your LAN, sometimes a more effective and quicker way for connection is the Static routes function rather than other methods. You may simply set rules to forward data from one specified subnet to another specified subnet without the presence of RIP. This function allows users to assign static routing information. In the Advanced group, choose Static Route. [. . . ] Check if the values of IP Address, Subnet Mask, Gateway IP Address and Primary DNS that you got from ISP are set properly or not. If you forget, please contact with ISP for getting new ones. 224 Vigor3300V+ Series User's Guide 2. 3. If anything wrong, please retype correct values and try the network connection again. After finishing the settings, go to System - Status page and click WAN Status. [. . . ]