User manual DREMEL 700 MOTO LATHE

[. . . ] Keep your hair, clothing and gloves away from flame. Loose clothes or long hair can catch fire. This allows you to use both hands to operate the tool. Do not use the appliance when it is leaking, shows any sign of damage or is malfunctioning. [. . . ] If the appliance is leaking (gas smell) immediately take it outside and check the tightness without a flame, please always use soap sud. Filling or refilling the gas cylinder must be done in a well ventilated place far away from any possible sources of ignition, open flames, pilot lights, electrical cookware and away from other persons. Be sure to observe the safety instructions and warning notices on the refill cylinder do not make any modifications to the appliance. Store your tool in an appropriate place with an ambient temperature between 10°C and 50°C. Allow your tool to cool off completely before storing. Unused tools should be stored away from children in a dry location. Always allow the tool to cool fully before removing / replacing tips and / or installing / replacing the nozzle. extremely flammable gas under pressure. Do not puncture or incinerate container or store at temperature above 50ºC. The unit, accessories and packaging should be sorted for environment-friendly recycling. Description Model number Power source Tank capacity Run time Heat-up time Nominal heat input (consumption) Cool-down time Temperature Dremel Versatip 2000 Refined butane gas ± 17 ml. Please allow 25 seconds of heat up time for tips. Make sure to use the right tip for the job you want to do. Only use tips that fit onto the tool perfectly. Loose fitting tips might result in an uncontrolled and unsafe flame. Slide in the catalyst into the flame guard with the narrow part facing outward. Place the flame guard and catalyst back on to the tool and securely tighten the flame guard nut. The soldering tip, cutting knife tip, shaping knife tip and hot blower tip can be screwed onto the catalyst. The wide flame head tip and the deflector tip can be slid over the end of the catalyst. Should the nozzle be clogged, follow these steps to replace the nozzle: 1. Install new nozzle with little opening facing outward. Put the ceramic insulator back and securely tighten it. [. . . ] Install new nozzle with little opening facing outward. Put the ceramic insulator back and securely tighten it. NOTE: A replacement nozzle can be ordered through your dealer. MOST COMMON USE Soldering tip: used for regular soldering activities, using soldering tin. [. . . ]