User manual DREMEL 754

[. . . ] Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control. [. . . ] In case of a complaint, send the tool undismantled together with proof of purchase to your dealer. Regulations; damage due to normal wear and tear, overload or improper handling will be excluded from the guarantee. Do not dispose of power tools into household waste!According the European Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its implementation into national right, power tools that are no longer usable must be collected separately and disposed of in an environmentally correct manner. For more information on the Dremel assortment, support and hotline, go to www. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. Use the power tool, accessories and tool bits etc. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. The drive adapter finger tight and then tighten an additional 1/3 turn with the wrench. Screw the attachment onto your rotary tool until the coupling is tight your rotary tool so that the speed control switch on the tool is easily accessible. (Figure F) BLADE ASSEMBLY Always use Dremel Saw Blades. Blades that do not match mounting hardware will run eccentrically, causing loss of control. Press the shaft lock button on your rotary tool. Pushing the guard foot up on the attachment, place the blade onto the mandrel arbor, making sure the arrows on the blade are facing out and the blade is resting flat on the shoulder of the mandrel arbor. Make sure the blade teeth point in the same direction as arrows on upper guard. While retracting the lower guard, check operation and condition, including the spring. [. . . ] Clean lower guard frequently to assure a rapid return of lower guard. This attachment is not intended for abrasive cut off wheels. If you attempt to cut without leveling and properly supporting the piece, the blade will tend to bind, causing KICKBACK and extra load on the rotary tool. (Figure J) Support the panel or boards close to the cut, as shown in (Figure K). [. . . ]