User manual DRILL DOCTOR 360X

[. . . ] It is sure to become a valuable tool because you will always have sharp drill bits before a project, during a project, and after a project. As president of this company, I am very proud of the quality of our products--and I am equally proud of the great people at Drill Doctor ® who design and produce them. If you have questions or need help with your Drill Doctor ® , please contact us and one of our customer representatives will be there to help. Use this User's Guide to learn to operate your Drill Doctor ® quickly and easily. [. . . ] 5 Peak C-weighted emission sound pressure level, LpC, peak (ref. This makes sure that the Drill Doctor creates the right geometry. It also sets the bit so that only a small amount of the tip is taken off during sharpening. This general-purpose point (normally 118°) is used for drilling softer materials like cold rolled steel, aluminum, and wood. Insert the bit into the front of the Chuck, leaving 1/2" of bit sticking out the front. It is important to understand that each bit has a Chisel Edge, a Cutting Edge, a Heel, a Relief Angle, and a Leading Edge. Tighten the Chuck by turning the Chuck Knob clockwise just to the point where the bit is snug but can still be slid in and out. The Chuck should not be completely tightened until we set the bit depth for sharpening in Step 4. When viewing a well-sharpened bit from the end, the entire surface from the Cutting Edge to the Heel will have a finely ground surface without ridges or indentations. The Heel will always be lower than the Cutting Edge; this is called positive relief. Note: A good test to see if the Chuck is tightened the correct amount is to make sure it moves when you pull on it with your fingers, but will not fall out when you turn the Chuck upside down. With the machine turned off, align the White Triangle on the Chuck with the Cam Guide. While keeping the Chuck against the Cam Guide on the 360X, insert the Chuck into the Sharpening Port. Push the Chuck all the way into the Port. tighten the Chuck Knob while it's still in the Sharpening Port. Remove the Chuck and make sure it is tight so the bit won't move when you sharpen it. Your depth is now set and you are ready to sharpen. Making sure that the Chuck rests firmly against the Cam Guide, turn the Chuck one half-turn to the right--to the other Sharpening Guide. Turn from Guide to Guide in a smooth and even motion until the bit is sharp. To sharpen both sides of the bit evenly, always use an even number of half-turns. The number of half-turns needed to sharpen the bit depends on its size. Turn the Chuck an even number of half-turns with light inward pressure: · Note: Use just enough pressure to keep the Cam against the Cam Guide. [. . . ] Re-assemble the Chuck and operate the Knob through its Chuck Jaws travel to ensure it turns freely. When the Knob is removed, be careful not to lose the small springs that separate the Chuck Jaws. Use wrench supplied with your Drill Doctor to lock sharpening wheel in place. You can double the life of the Diamond Sharpening Wheel by reversing it before you replace it. [. . . ]