User manual DSC ESCORT 5580TC V3.0

[. . . ] ·WARNING· This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer. Instruction Manual ESCORT558OTC Version 3. O FCC COMPLIANCE STATEMENT CAUTION: Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your authority to use this equipment. This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for Class B device in accordance with the specifications in Subpart "B" of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in any residential installation. [. . . ] To hear the trouble conditions present on your system/partition disarm the system (depending on the control panel you have, your system may allow you to enter the Trouble menu without first disarming the system/partition). Access the security system (Section 2--Accessing Your Security System) and select a partition (Section 2. 5--If You Have a Multiple Partition System). You will hear the prompt: " For System Troubles, press [2]. " Press [2] and the system will announce one or more of the trouble conditions from the list below, if any are present. If no trouble conditions are present, the system will announce: " There are NO System Troubles. To exit, press [#]. " The following describes the various trouble conditions that your system might announce: Announcement: "Service is required" "AC Power Trouble. " "Phone line trouble. " "Communication trouble. " " Zone Fault, press [5]. " "Zone tamper, press [6]. " "Device low battery, press [7]. " "The time and date are incorrect. " Problem and how it should be addressed: If this message and no other trouble condition is announced, call for service. Electrical power to the system has been interrupted. Check your fuse box or circuit breaker to ensure that the electricity supply for the system is on. If this does not correct the problem, call for service. Your system has detected a problem with the telephone line. If this problem does not correct itself, or happens frequently, call for service. Your system has been unsuccessful in communicating an event to your central station. If you hear this message, call for service immediately. Your system has detected a Zone Fault on one or more zones. Press [5], and the system will announce which zones have a fault. If you are unsure of how to clear a zone fault, call for service. Your system has detected a Zone Tamper on one or more zones. Press [6] and the system will announce which zone(s) have tampers. If you are unsure how to clear the zone tamper, call for service. Your system has detected that one or more of the wireless devices on the system has a low battery. Press [7], and the system will announce which devices have a low battery. If this does not correct the problem, call for service. If all power to the system is interrupted (AC and battery), the system clock and date will need to be reset. [. . . ] Such damages include, but are not limited to, loss of profits, loss of the product or any associated equipment, cost of capital, cost of substitute or replacement equipment, facilities or services, down time, purchaser's time, the claims of third parties, including customers, and injury to property. Disclaimer of Warranties This warranty contains the entire warranty and shall be in lieu of any and all other warranties, whether expressed or implied (including all implied warranties of merchantability or fitness for a particular purpose) And of all other obligations or liabilities on the part of Digital Security Controls Ltd. neither assumes nor authorizes any other person purporting to act on its behalf to modify or to change this warranty, nor to assume for it any other warranty or liability concerning this product. This disclaimer of warranties and limited warranty are governed by the laws of the province of Ontario, Canada. recommends that the entire system be completely tested on a regular basis. [. . . ]