User manual DSC PC1555

[. . . ] About Your Security System Your DSC security equipment has been designed to provide you with the greatest possible flexibility and convenience. Read this manual carefully and have your installer instruct you on your system's operation and on which features have been implemented in your system. All users of this system should be equally instructed in its use. Fill out the "System Information" page with all of you zone information and access codes and store this manual in a safe place for future reference. Fire Detection This equipment is capable of monitoring fire detection devices such as smoke detectors and providing a warning if a fire condition is detected. [. . . ] (*2) to View <> View Trouble <> Use the arrow (< >) keys to view which troubles are present on the system. Once "Trouble Message" you have scrolled through the list of troubles, press the [#] key to exit the Trouble Viewing mode and return to the Ready state. 11 Setting the System Date and Time To set the system time, enter [D] [6] followed by the Master Code. The keypad will now accept 10 consecutive digits: · Enter the Time in Hours and Minutes using the 24 Hour format (00:00 to 23:59). · Enter the Date in Months, Days and Years (MM DD YY). NOTE: If you have an LCD keypad, your installer may have programmed your system to display the time and date while the keypad is idle. If this is the case, you may have to press the [#] key to clear the date and time before entering an access code to arm the system, or before performing any other keypad function. Testing Your System Alarm Test The Alarm Test provides two second test of the keypad sounder and bell or siren. Begin with the panel in the Ready state. From an LED keypad, Enter [D][6][Master Code][4] then press [#] to return to the Ready state. From an LCD keypad, press [D] to enter the functions list. Use the arrow (< >) keys to scroll to find "User Functions" and press [D] to select. Enter your Master Code and scroll to find the following message. . . Select Option <> Press [D] to perform an Alarm Test. The keypad will display the following message. . . System Test System Test In Progress Press [#] to return to the Ready state. Full System Test We recommend that you test your system weekly. Should the system fail to function properly, call your installation company immediately for service. NOTE: Perform system tests during off-peak hours, such as early morning or late evening. Inform the monitoring station that you are testing your system. Begin with the system in the Ready state. Perform a Bell/Battery test by pressing [D][6][Master Code][4]. The bell and keypad buzzer will sound for two seconds and all keypad lights will turn ON. open a door/window or walk in motion detector areas). From an LED keypad, observe the zone light turn ON when the zone is activated. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: n Re-orient the receiving antenna. n Increase the separation between the equipment and receiver. n Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]