User manual DSC PC585 INSTALLATION MANUAL

[. . . ] WARNING This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer. The entire manual should be carefully read. Installation Manual Software Version 2. 3 / DLS-1 v6. 7 and up See Back Cover for New Features in Version 2. 3 WARNING Please Read Carefully Limited Warranty Digital Security Controls Ltd. warrants the original purchaser that for a period of twelve months from the date of purchase, the product shall be free of defects in materials and workmanship under normal use. During the warranty period, Digital Security Controls Ltd. [. . . ] The 3rd Telephone Number can be used to back up the 1st in this situation. (See 5. 7 "Communicator ­ Telephone Numbers" on page 17. ) If a later communication attempt is successful, the FTC reporting code(s) programmed in section [351] will be transmitted along with the unreported events from an earlier unsuccessful communication. When Bell on FTC when Armed is enabled in programming section [702], option [8], an FTC during the armed period will sound an Audible Alarm for the length of Bell time-out or until the system is disarmed. If FTC Trouble Only when Armed is enabled, only the keypad buzzer will sound trouble beeps every 10 seconds until a key is pressed. Post Dial Wait for Handshake determines the amount of time the panel will wait for a valid handshake from the receiver. If the panel does not hear the handshake it will consider the call a failed attempt, hang up and try again. The Pulse Dialing Make/Break Ratio option can change the Make/Break ratio to 33/67 from the North American ratio of 40/ 60. With ID Tone Enabled the panel will pulse a tone on the telephone line to indicate that the panel is on the line. The 2100Hz/1300Hz ID Tone option selects the frequency of the ID tone that is pulsed on the line. NOTE:Contact your local telephone company to confirm which settings should be used. . Section [380]: [3] Switch to Pulse Dialing on Fifth Attempt . . Section [380]: [4] Communicator Enable/Disable . . Section [380]: [1] Communicator Call Direction Options . . Section [702]: [2] Delay Between Dialing Attempts . . Section [701]: [6] Maximum Dialing Attempts . Section [160] Post Dial Wait for Handshake . Section [161] Pulse Dialing Make/Break Ratio. . Section [702]: [5] 2100Hz/1300Hz ID Tone . . Section [702]: [6] Bell on FTC/Trouble Only . . Section [702]: [8] 5. 6 Communicator ­ Account Numbers The account number is used by the central station to distinguish between panels. There are two account numbers programmable for the PC585. Section [310] Second Account Code (4 digits) . [. . . ] CHANGES IN TELEPHONE COMPANY EQUIPMENT OR FACILITIES The telephone company may make changes in its communications facilities, equipment, operations or procedures, where such actions are reasonably required and proper in its business. Should any such changes render the customer's terminal equipment incompatible with the telephone company facilities the customer shall be given adequate notice to the effect modifications to maintain uninterrupted service. RINGER EQUIVALENCE NUMBER (REN) The REN is useful to determine the quantity of devices that you may connect to your telephone line and still have all of those devices ring when your telephone number is called. In most, but not all areas, the sum of the RENs of all devices connected to one line should not exceed five (5. 0). [. . . ]