User manual DSC POWER 632 V2.3 REV3

[. . . ] WARNING This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer. The entire manual should be carefully read. Instruction Manual PC1555/PC1555MX Software Version 2. 3 LIMITED WARRANTY Digital Security Controls Ltd. warrants the original purchaser that for a period of twelve months from the date of purchase, the product shall be free of defects in materials and workmanship under normal use. During the warranty period, Digital Security Controls Ltd. [. . . ] Bypassing zones reduces your security protection. If you are bypassing a zone due to damaged wiring or contacts, please call a service technician immediately so that the problem can be resolved and your system returned to proper working order. Make sure that no zones are unintentionally bypassed when arming your system. To bypass zones from an LED or Fixed Message LCD5501Z keypad: Start with the system in the Ready state. Enter the zone(s) as a 2-digit number from 01 to 32. As each zone is bypassed, the corresponding zone light will turn ON. If a zone is bypassed by mistake, enter that zone number again; the zone light will turn OFF, indicating that the zone is not bypassed. Press [#] to return to the Ready state. To bypass zones from an LCD keypad: To bypass a zone, the system must be in the Ready state. The display will read. . . Enter Code to Arm System Press the [] key to enter the function menu. The display will read. . . Press (*) for <> Press the [] key to enter the zone bypassing mode. Zone Bypass Zone Search "Zone Name" Zone Search "Zone Name" Zone Search "Zone Name" <> Use the arrow (< >) keys to find the zone to be bypassed and press the [] key to select it. The display will read. . . <> "B" will appear on the display to show that the zone is bypassed. To unbypass a B zone, enter the zone number; the "B" will disappear from the display to show that the zone is no longer bypassed. <> This display will be shown if a zone was open when you entered the bypassing O command. The open zone will be represented by "O". If you bypass the open zone, a "B" will replace the "O". To exit the bypassing mode and return to the Ready state, press the [#] key. Viewing Trouble Conditions The control panel continuously monitors a number of possible trouble conditions. If one of these trouble conditions occur, the keypad will beep twice every 10 seconds until you press any key on the keypad. NOTE: A TROUBLE condition reduces the security your system is designed to provide. Call your installing company for service. 11 To view troubles from an LED or Fixed Message LCD5501Z keypad: A trouble will be indicated by the Trouble light/message, which will remain ON until the trouble condition is cleared. If you cannot determine the cause of the trouble condition, contact your installer for assistance. To view the type of trouble condition, press [][2]. One or more zone indicators will turn ON, indicating the various trouble conditions: ZONE iNDICATOR TYPE OF TROUBLE 1 . . . . . . . . . . . . . . . . . Call your installation company for service. [. . . ] Every installation should be evaluated by a security professional to ensure that all access points and areas are covered. Locks and latches on windows and doors must be secure and operate as intended. Windows, doors, walls, ceilings and other building materials must be of sufficient strength and construction to provide the level of protection expected. A reevaluation must be done during and after any construction activity. [. . . ]