User manual DUAL SX

[. . . ] SX652 SX692 INSTALLATION/OWNER'SMANUAL CarAudioSpeakers SXSERIES SXSERIESPREPARATION GettingStarted Thank you for purchasing the SX Series car speakers. Although Dual has attempted to make sure all of the information contained within this manual is accurate, please be aware that any part of it is subject to change without notice. Safety This symbol is intended to alert the user to the presence of important instructions. Failure to heed these instructions can result in injury or unit damage. To prevent injury and damage to the unit, please read and follow the instructions in this manual. [. . . ] Never run speaker wires underneath your vehicle. Running speaker wires inside the vehicle provides the best protection from exhaust heat and environmental elements. Avoid running wires over, near, or through sharp edged surfaces. We suggest you also use rubber grommets to protect any wires routed through metal, especially the firewall. 3 SXSERIESINSTALLATION Mounting 1. Determine where the speakers will be mounted. Make sure the area is large enough for the speaker to mount evenly. Also ensure the mounting location is deep enough for the speaker to fit. Refer to the specification chart to determine the proper diameter hole to cut for your speaker model. If supplied, use the plastic mounting ring as a template to mark the locations for the mounting screws. Be sure to observe proper polarity when connecting the wires. The speaker's positive terminal is indicated with a "+" symbol. Mount the speaker using the supplied screws. If the speaker grill is to be used, insert 4 screws into the grill holes and then mount the speaker. Standard Door Installation Grille Speaker Mounting hole Cut-out Standard Rear Deck Installation Grille Mounting hole Cut-out Speaker 4 SXSERIESINSTALLATION Mounting The diagram featured above is to be used in conjunction with the specifications matrix guide below: er ) De pt h Gr (H illD xW im xD en )o sio r( ns Hx Di am Mo un Cu t-o Bo SX652 SX692 FractionalInches 7" x 5/8" 10 7/16" x 7 9/16" x 11/16" 2 1/4" 3 5/16" 2 7/16" 3 1/2" 3/4" 11/16" 9/16" 1/2" 5 3/4" 6" x 8. 75" 90 90 60Hz - 23kHz 55Hz - 23kHz 75 225 4 4 100 300 Se To yR Re es c po (w om ns at me e ts n de Pe RMS d ak ) Po (w P we at ow r ts e IP r P) Im pe da nc e et h pt tru sio g n De tin h et er un tin g ou n pt iam P ro De ty ivi ns it (d Fr e qu B) Mo tin er m Tw ee t p- tto ut en c -M D g 5 SXSERIESINSTALLATION LimitedOne-YearWarranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. agrees, at our option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new, renewed or comparable product (whichever is deemed necessary) in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase. Subsequent replacement products are warranted for the balance of the original warranty period. [. . . ] For more information and for the location of the nearest authorized service center please contact us by one of the following methods: Call us toll-free at 1-866-382-5476 E-mail us at cs@dualav. com Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company's negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages. 6 SXSERIESWARRANTY Notes 7 Dual Electronics Corporation Toll Free: 1-866-382-5476 www. dualav. com ©2008 Dual Electronics Corp. [. . . ]