User manual DUNE HD SMART H1

[. . . ] HDD player: connect an HDD to the player and play content directly from the HDD. Network player: connect the player to a local network and play content directly from PC or NAS (UPnP, SMB, NFS). MKV player: play HD and SD video in a popular MKV format and other modern video file formats, including top quality HD video with very high bitrate. RealD: watch 3D video in this ultra modern format used in cinema for the latest movies. [. . . ] The main screen shows items allowing to use different player functions and access all storage devices and network drives connected to the player. Adjust the player settings as needed using "SETUP" item on the main screen of the player menu (or by pressing the "SETUP" RC button). in particular , you may want to adjust video settings , audio settings , and network settings. To choose the language of the player menu, use "Setup / General / Interface language" setting. Use the RC buttons "LEFT", "RIGHT", "UP", "DOWN", "ENTER", "RETURN" to navigate through the player menu. use the "POP UP MENU" RC button to show the list of available commands. Use the "INFO" RC button to show the information about the selected item. The "MODE" RC button allows quick setting of video output mode without entering the player setup menu. This way of video output configuration may be required if you see no picture on the screen after connecting your player to a TV. Press the "MODE" RC button and then one of the RC buttons "1", "2", "3", "4", or "5" to switch to one of the following video output modes respectively: 1. HDMI, 1080i, 60 Hz After you see a picture on the TV, press the "ENTER" RC button, and then go to the player setup menu to perform a more precise configuration of the video output mode if needed. NOTE: The procedure of quick setting of video output mode can not be used during playback. To ensure this procedure can be used, switch the player off, then switch the player on, and the wait about 1 minute to ensure the player loading is finished. 5" SATA HDD, ensure you are on the main screen of the player menu, open the HDD rack door, insert the HDD into the HDD rack and close the HDD rack door. The player will recognize the internal HDD, and will show an item corresponding to the internal HDD on the main screen of the player menu. Do not eject the internal HDD when some write operation is in progress. It is recommended to use "green" HDD models with small RPM value, small heat emission, and small power consumption; for more information, please see here: http://dune-hd. To connect a USB drive, ensure you are on the main screen of the player menu and connect the USB drive to an USB port of the player. The player will recognize the USB drive, and will show an item corresponding to the USB drive on the main screen. When connecting a USB drive requiring significant power (such as USB HDD), use an external power supply for the USB drive. Power provided by the USB ports of the player may not be enough for correct functioning of the USB drive. Do not disconnect or switch off the USB drive when some write operation is in progress. [. . . ] NOTE: After switching off the player or putting the player into the «hardware standby» mode, it is recommended to wait about 1 minute before switching it on again. You can access storage devices connected to the player from the local network using FTP and SMB protocols. On a Windows PC, just type "ftp://ip_address" or "\\ip_address" in the Windows explorer, where "ip_address" is the IP address of the player. You can use a USB WiFi adapter to connect the player to the local network via WiFi. [. . . ]