User manual DURACRAFT DH-722

[. . . ] Never allow the power cord to be immersed in water or other liquid. This product is equipped with a polarized AC-line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. NEVER connect the vaporizer to any power source other than a 120V polarized outlet. [. . . ] Be sure to thoroughly mix the Baking Soda or DuraStart with the water in the Base. NOTE: Adding too much baking soda or DuraStart can cause boiling and/or hot water spurting, which may cause burns. If the Vaporizer boils excessively, spurts hot water or blows fuses. . . Your water's mineral content is too high. · Make sure no chemicals have been added to the water. If any chemicals were added, turn off and unplug the vaporizer. Empty Base and refill with tap water only. · If no chemicals have been added, turn off and unplug the vaporizer. · Refill using 1/2 tap water and 1/2 distilled water, which will lower the mineral content of your water and prevent excessive boiling. · When you are finished using the vaporizer, unplug it and clean after each use. · ALWAYS be sure to discard any unused water in the base before storing or refilling. FEATURES A U T O - S H U T O F F F E AT U R E : · The vaporizer will shut off when the water level drops below the bottom of the Steam Assembly. · Refill the Base per the FILLING instructions. · Once filled, the vaporizer will automatically turn back on. MEDICINE CUP: A medicated vapor can be distributed into the air by using the Medicine Cup at the top of the Steam Assembly. Fig. 3 Place Medicine Here To add medicine to the Medicine Cup: 1. Unplug the vaporizer and allow at least 10 minutes for the unit to cool. Carefully add liquid medication; fill cup only halfway (Fig. After use, clean any residue from the cup. WARNING: DO NOT use any liquid medicine other than those specifically recommended for use with a steam vaporizer. DO NOT pour medicine directly into the water as this may cause excessive boiling or spurting of hot water. Honeywell assumes no responsibility for consequences resulting from the uses of medication in this vaporizer. CLEANING We recommend cleaning the vaporizer daily by wiping all surfaces dry using a paper towel or soft sponge. It is normal for mineral deposits to collect at the bottom of the Base. Deposits may appear as black flecks and should be rinsed out after every use. DAILY WEEKLY The vaporizer should also be cleaned once a week, according to the instructions listed below. [. . . ] If any chemicals were added, turn off and unplug the vaporizer. Empty the water tank and refill with tap water only. · If no chemicals have been added, turn off and unplug the vaporizer. · Refill using 1/2 tap water and 1/2 distilled water, which lower the mineral content of your water and prevent excessive boiling. CARE PRODUCTS If your local dealer is out of stock, Duracraft® replacement parts and care products may be ordered directly. [. . . ]