User manual DURKOPP 367 INSTRUCTIONS FOR FITTING FOR KIT 0367 595144

[. . . ] The non-observance of the following safety instructions can cause bodily injuries or damages to the machine. The machine must only be commissioned in full knowledge of the instruction book and operated by persons with appropriate training. Before putting into service also read the safety rules and instructions of the motor supplier. The machine must be used only for the purpose intended. [. . . ] Should the pressure of your supply line be higher than 6 bar, it has to be reduced to 6 bar at the supply unit of the sewing machine!Before you start the installation: Please check whether all components of the retrofit kit are included in the scope of delivery. The complete mounting kit for the pneumatic foot lift with the order number 0367 595144 consists of the following components: 3 m Hose 1 2 1 1 1 1 1 1 1 1 2 1 1 1 Connection WI-N Screw connection GD-E Screw connection WI-E Cylinder Bars Fastening clip Maintenance unit Pressure line Coupling box Coupling plug (at the pressure line) Ideal clip (1x at the pressure line) Hose nozzle Allen screw Pneumatic device plan Switch off the main switch and pull out the mains plug before you start to install the pneumatic foot lift. The installation must be done by qualified technicians only. Loosen the 6 screws of the oil pan and take the oil pan off. Remove the locking washer 3from the right end of the slide bar 2 and the screw 1 from the left end of the slide bar 2. remove the slide bar 2 from the finger on the right. Run the hose 6 through the fixture 5 at the rear panel of the machine. push the hose 6 on the connection 8 of the cylinder 4. Fit the cylinder 4 instead of the slide bar 2. The piston must show to the right and the throttling screw 7 must show down. If you turn the throttling screw 7 counter-clockwise, the piston is moving more quickly. If you turn the throttling screw 7 in clockwise direction, the piston is moving more slowly. Put the locking washer 3 on the right of the cylinder 4 again and screw in screw 1 on the left again. run the hose 6 to the right at the rear panel of the machine. Run the hose outside through the cut-out 9 down on the right of the sewing machine. Now you have to guide the hose downward with the connection WI-N 12. For this purpose put the fastening clip 10 on the hose 6. In order to measure the length of the hose 6, hold the fastening clip 10 close to the drill-hole down on the right of the sewing machine. Cut the hose 6 off behind the fastening clip 10. connect the hose ends with the connection WI-N 12. Screw the hose 6 with the fastening clip 10 (directly at the connection WI-N 12 with the Allen screw 11) on the drill-hole down on the right of the sewing machine. [. . . ] Guide the hose coming out of the sewing machine to the new bars 3. Cut the hose off in such a way that it is not under tension and push it into the screw connection GD-E 6. Connect the screw connection GD-E 5 and the screw connection WI-E 9 at the maintenance unit with the remaining hose. Screw the coupling box 11 on your pressure supply. [. . . ]