User manual DYMO LETRATAG QX50

[. . . ] Press the tab on the front side of the cassette cover (figure B) and open cover. insert the cassette , the cassette inserts with the tape exiting to the top of the machine. Gently press on the center of the tape until it clicks into position. [. . . ] Note: For a fixed length label the text is always centered. The --ll-- will show on the display in between the labels to indicate the beginning/ end of each label that is stored in the memory. Press the key + Q to move to the beginning of the buffer or + R to move to the end of the buffer. The labels will remain in the memory buffer, even if the unit is turned off. If you try to type when the memory buffer is full, the message ERROR 4 will be displayed. Delete part or all of the text in the buffer in order to store a new label in the memory. To clear the entire memory buffer, press the + . This feature allows you to review all the text/labels stored in the extended memory. Use the H or P arrows on the Navigation Key to set the desired number of copies (1-9). Once you have entered the correct number of copies press and the labels will print the text. The labels will print in one continuous label with a vertical chain mark to indicate where to manually cut the labels. The labelmaker default setting is English with additional international character sets that can be accessed by selecting a different language. The selection of a language defines which diacritical characters (see next section), measurement setting and currency symbols can be accessed. For example, if Spanish is selected then the diacritical characters for Spanish will be available first with the measurements in millimeters and the currency pesos. To return to English setting repeat steps 1-4. Diacritical Characters/Accented Characters Many diacritical marks (accented characters) and extra characters relevant to a specific language setting are stored and can be accessed by selecting a language. Once a specific language set is selected, the diacritical and extra characters are accessed for the specific language as follows: If the key is tapped repeatedly within a short time, you can scroll through a list of all the diacritical characters for that letter. Additional blank label tape (1/2 inch or 12mm) will exit from the unit when the Key and the Key are pressed. [. . . ] Labels have easy peel split back tape for easy removal of the tape backing. Preview label before printing by pressing and holding the Key and Key. the label text will scroll across the display once. [. . . ]