User manual DYNATEK D3K7-5

[. . . ] • to install the oven under the counter (see diagram) and in a kitchen unit, the cabinet must have the following dimensions: 560 mm . 45 m m. Centring and fastening Position the 4 tabs on the side of the oven according to the 4 holes of the outer frame. Adjust the tabs according to the thickness of the cabinet side panel, as shown below: thickness of 20 mm: take off the removable part of the tab (see diagram) thickness of 18 mm: use the first groove, which has already been set in the factory (see diagram) 23 mm. 595 mm. 567 mm. 558 593 mm. 45 m m. mm . thickness of 16 mm: use the second groove (see diagram) 595 5 mm. mm . . 545 mm . 24 mm !The appliance must not come into contact with electrical parts once it has been installed. The consumption indications on the data plate have been calculated for this type of installation. Secure the appliance to the cabinet by opening the oven door and putting 4 screws into the 4 holes of the outer frame. [. . . ] 58 voltage: 240V~ 50/60 Hz maximum power absorbed 2400W This appliance conforms to the following European Economic Community directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; -89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments; - 93/68/EEC of 22/07/93 and subsequent amendments. 3 Description of the appliance GB Overall view Control panel GUIDES for the sliding racks position 5 position 4 position 3 position 2 position 1 GRILL DRIPPING PAN Control panel SELECTOR Knob TIMER knob* THERMOSTAT Knob Indicator light THERMOSTAT * Only on certain models 4 Start-up and use !The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may produce a slightly unpleasant odour caused by the burning away of protective substances used during the manufacturing process. Oven light It goes on when selecting with the SELECTOR knob. It stays on when a cooking mode is selected. GB How to use the timer* 1. To set the buzzer, turn the TIMER knob clockwise almost one complete revolution. Turn the knob anticlockwise to set the desired time: align the minutes shown on the knob with the indicator on the control panel. The timer operates in minutes: when the selected time has elapsed, a buzzer will sound. The timer does not turn the oven on or off. Starting the oven 1. Select the desired cooking mode by turning the SELECTOR knob. Always cook in this mode with the oven door closed. GRATIN mode The top heating element, as well as the fan, will come on. This combination of features increases the effectiveness of the unidirectional thermal radiation of the heating elements through forced circulation of the air throughout the oven. This helps prevent food from burning on the surface, allowing the heat to penetrate right into the food. Always cook in this mode with the oven door closed. Practical cooking advice !Do not place racks in position 1 and 5 during fanassisted cooking. Excessive direct heat can burn temperature sensitive foods. In the GRILL and GRATIN cooking modes, place the dripping pan in position 1 to collect cooking residues (fat and/or grease). MULTI-COOKING • Use position 2 and 4, placing the food that requires more heat on 2. • Place the dripping pan on the bottom and the rack on top. GRILL • Insert the rack in position 3 or 4. Place the food in the centre of the rack. [. . . ] Make sure you don't touch them and keep children well away. • Ensure that the power supply cable of other electrical appliances does not come into contact with the hot parts of the oven. • The openings used for ventilation and dispersion of heat must never be covered. • Always grip the oven door handle in the centre: the ends may be hot. [. . . ]