User manual DYNATEK DS2-2

[. . . ] If there is any doubt, contact a professionally qualified technician and do not use the appliance. All packaging (plastic bags, polystyrene foam, staples, etc. ) should be kept out of reach of children as it presents a potential hazard. 4 The appliance must be installed by a qualified individual in compliance with the instructions provided. The manufacturer shall not be held responsible for any harm caused to individuals or animals, or for any damage to personal property resulting from incorrect installation. [. . . ] The cooker has the following technical features: Class: 1 The maximum dimensions of the cooker are listed in the figure on page 2. To ensure the appliance operates correctly if installed inside a cabinet, the minimum distances indicated in fig. Furthermore, adjacent surfaces and the rear wall must be able to withstand a temperature of 65°C. There are 4 adjustable feet on the lower part of the cooker; these can be used to level the cooker when necessary. The appliance must be positioned so that it is level. Warping resulting from bad positioning can alter the features and performance of the appliance. Fig. 10 4 Electrical connection THE APPLIANCE MUST BE EARTHED The appliance is designed to work with alternating current at the supply voltage and frequency indicated on the rating plate (situated on the rear part of the appliance and on the last page of the instruction booklet) or at the end of the instruction booklet. Make sure that the local supply voltage corresponds to the voltage indicated on the rating plate. ATTENTION: This appliance has a maximum power exeeding 3kW; it is therefore necessary for it to be connected to a socket able to support a rated current higher than 13A (the appliance rated current is 15A). Connecting the supply cable to the mains electricity supply A 13. A plug in compliance whit BS 1362 is not suitable. To connect directly to the mains supply, a double-pole switch with a contact separation of at least 3 mm suitable for the load and complying with current standards and regulations, must be fitted between the appliance and the mains supply outlet. • Do not use cookware which has been used with gas burners. The concentration of heat from gas burners is such that it may warp the base of the pan, and therefore the desired result will never be achieved if it is then used on the glass ceramic hob. Soups and sauces Cooking at boiling point Pan-roasting Boiling large quantities Frying 7 MULTIFUNCTIONAL ELECTRIC OVEN G B The oven offers new, different combinations of electrical heating elements; by selecting the most suitable combination for the dish you wish to cook, the results achieved will be very precise. Only place the foods to be cooked in the oven when the selected temperature has been reached and, if possible, use only one shelf. If you wish more heat to be generated below or above (heat from the dish, turn the selector to position (heat from below + fan) or (heat from below), above). • With function (fan), cooking takes place through the action of air which has been preheated by a heating element and which is then circulated inside the oven by a fan. The oven heats up very quickly, therefore the foods you wish to cook may also be placed inside the oven as soon as it is switched on. It is also possible to cook using two shelves at the same time. • The “quick defrosting” function takes place without using the heating elements; only the oven light and the fan are activated. 8 TIMER (ELECTRIC OVEN) This feature allows you to program the oven or the grill as follows: • Delayed cooking start time with a specified duration; • Immediate start with a specified duration; • Timer. Button functions: : timer with hours and minutes; : cooking time; : cooking end time; : -: +: manual change; set cooking time (countdown); set cooking time (counting upwards from zero). When the text “auto” appears, this indicates that the cooking duration and the time it is due to finish have been programmed in automatic mode. At this point, the oven will switch on automatically at 12:30 and switch off after 30 will minutes. [. . . ] • Do not use sharp objects to remove any crusted-on residue, as doing so may scratch the self-cleaning surface. • If the self-cleaning surfaces inside the oven are damaged or rendered unusable due to maintenance procedures being forgotten or performed incorrectly over a number of years, it is possible to request a self-cleaning panels kit, which can be used to coat the inside of the oven. To order this kit, please contact one of our authorised Assistance Centres. Outer areas of the oven: • Only perform this cleaning procedure when the oven is cold. [. . . ]