User manual DYSON DC25 ANIMAL

[. . . ] Ensure all parts including clear binTM are securely attached before use or carrying the machine. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Unplug from outlet when not in use, and before performing user maintenance, connecting or disconnecting the hose or changing accessories. [. . . ] Push wand down into hose and attach tool to the side of the machine. Using your Dyson Press foot pedal and recline handle to use. The stabiliser stand will automatically lift up. To switch `ON', depress power button in front of handle. When finished cleaning, push machine into an upright position and stabiliser wheels will automatically drop. Use the bin carrying handle to carry the machine. Caution: (i) (ii) When returning to the upright position, ensure that the stabiliser wheels are fully engaged before releasing the cleaner. Do not press the cyclone release button while carrying the machine or it could fall and cause injury. Fine dust such as plaster or flour should only be vacuumed in very small amounts. Consult your flooring manufacturer's recommended instructions before vacuuming and caring for your flooring, rugs and carpets. Some carpets will fuzz if a rotating brushbar is used when vacuuming. If this is the case, we recommend vacuuming in hard floors mode and consulting with your flooring manufacturer. (See `Hard floors or carpets' section. ) If used in a garage for car cleaning, care should be taken to wipe the soleplate and wheels with a dry cloth after vacuuming to clean off any sand, dirt, or pebbles which could damage delicate floors. Please note: (i) (ii) (iii) Hard floors or carpets The brushbar will always default to `ON' (spinning) each time you switch on the machine and recline it for cleaning. The brushbar will automatically stop if it becomes obstructed. If the brushbar stops during use, please refer to the `Clearing brushbar obstructions' section. for hard floors), recline the machine and turn it `ON', then press the brushbar `ON/OFF' button ­ the brushbar will stop spinning. High-reach cleaning Caution: (i) (ii) Powerful suction can cause the hose to `pull back' ­ please take care. To avoid personal injury and to prevent the machine from falling when cleaning stairs, do not work with the vacuum above you on the stairs. To release the wand, open the wand cap. Extend the red tube until the handle slides off the machine. Tools can be attached to either the hose or wand. Ensure wand cap is closed when wand is not in use. Emptying the Clear binTM Caution: (i) Switch `OFF' and unplug machine before emptying the bin. Empty as soon as the dirt reaches the level of the MAX mark ­ do not overfill. To remove the clear binTM from the machine press the button at rear of carrying handle. To release the dirt, press the red bin release button. [. . . ] Beware of sharp objects when clearing blockages. Refit all parts of the machine securely before using. Clearing blockages is not covered by your machine's limited warranty. If any part of your machine becomes blocked, it may overheat and then automatically shut off. [. . . ]