User manual DYSON DC40

[. . . ] OPERATING MANUAL INSTRUCCIONES DE SEGURIDAD ASSEMBLY ARMADO clik WASH FILTERS Wash filters with cold water at least every month. IMPORTANT SAFETY INSTRUCTIONS BEFORE USING THIS APPLIANCE READ ALL INSTRUCTIONS AND CAUTIONARY MARKINGS IN THIS MANUAL AND ON THE APPLIANCE When using an electrical appliance, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: WARNING 1. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY: This Dyson appliance is not intended for use by young children or infirm persons with reduced physical, sensory or reasoning capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction by a responsible person concerning use of the appliance to ensure that they can use it safely. Close attention is necessary when used by or near children. [. . . ] ATTACHMENTS • • To release the wand, open the wand cap and pull the red tube up and away from the handle until it clicks into place. Should you wish to use the hose without the wand, follow the above instruction and press the red button to release the wand from the hose. CLEANING THE CLEAR BIN • • Remove the cyclone and clear bin (instructions above). To separate the cyclone unit from the clear bin press the red button to open the clear bin base. This exposes a small silver button behind the red opening mechanism. Press the silver button and separate the cyclone unit from the clear bin. Clean the clear bin with cold water only. Ensure the clear bin is completely dry before replacing. Do not use detergents, polishes or air fresheners to clean the clear bin. Do not put the clear bin in a dishwasher. Do not immerse the whole cyclone unit in water or pour water into the cyclones. Clean the cyclone shroud with a dry cloth or dry brush to remove lint and dust. To refit: – f it the cyclone shroud into the clear bin so that the silver button clicks and  engages – close the clear bin base so it clicks into place – push the cyclone and clear bin unit into the main body of the appliance;  it will click into place – ensure the cyclone and clear bin unit is secure. CARPETS OR HARD FLOORS • • • The brush bar will always default to ‘ON’ (spinning) each time you switch the appliance ‘ON’ and recline it for cleaning. The brush bar will not rotate when the appliance is upright. For delicate rugs and hard floors): – switch the appliance ‘ON’ – recline the appliance – press the brush bar ‘ON/OFF’ button – the brush bar will stop spinning. Before vacuuming your flooring, rugs and carpets, check the manufacturer’s recommended cleaning instructions. Some carpets may fuzz if a rotating brush bar is used when vacuuming. If this happens, we recommend vacuuming in ‘hard floor’ mode and consulting with the flooring manufacturer. The brush bar on the appliance may damage some carpet types. If you are unsure, turn ‘OFF’ the brush bar. • • • • • • • • • • • WASHING YOUR FILTERS • • • • • • • • • Your appliance has two washable filters , located as shown. [. . . ] You may also have other rights which vary by State. This limited warranty is not transferable. € • • • • • • BRUSH BAR – TROUBLESHOOTING • • If the brush bar has stopped spinning, follow the instructions above on clearing obstructions. Alternatively, contact a Dyson expert on the Dyson Helpline or visit the website. [. . . ]