User manual E-PIL MEDOSE

[. . . ] A small "W" will appear in the display (top left) when the MeDose is in Vibration mode. The MeDose will give a brief alarm on the hour if the chime function is on. HOW TO SET THE CORRECT TIME · Tap button C until mode prompt "TIME" is reached. · Press & hold button D for 5 seconds to enter setting mode. The seconds will start flashing · Tap C · Tap A until the correct Hour is reached. [. . . ] If "ON" is not showing you can toggle to ON by tapping A. Proceed to your next alarm by tapping B. RESET Press all four buttons for 5 seconds and release. This will re-set the internal computer (this only needs to be done after a battery change). HOW TO USE COUNT DOWN TIMER The MeDose watch offers three count down timer modes. Each mode can be up to 99 minutes and 59 seconds long (1 hour and 40 minutes). · Tap button B to select Count Down Stop (CS), Count Down Up (CU), or Count Down Repeat (Cr) function. HOW TO SET AN ALARM SPECIFIC DATE AND TIME · · Tap button C until mode prompt "ALARM" is reached. Tap button B to go to the alarm you want to set. Alarm-1 is AL-1, Alarm-2 is AL-2, Alarm-3 is AL3, Alarm-4 is AL-4, Alarm-5 is AL-5, Alarm-6 is AL-6 and CHIME is the 7th alarm. Once you have made your count down selection: · · · · · · Press & hold button D for 5 seconds to enter setting mode. Tap A until the correct Minute is reached. Tap C Tap A until the correct Second is reached. Tap C Tap D to leave setting mode. For each SPECIFIC alarm do the following: · · · · · · · · · · · Press & hold button D for 5 seconds to enter setting mode. Tap A until the correct Hour is reached. Please note the PM indicator above the Seconds. Tap C Tap A until the correct Minute is reached. Tap C Tap A until the correct Month is reached. Tap C Tap A until the correct Day of the Month is reached. Tap C Tap A for the correct Time Zone (T1or T2) Tap D to leave setting mode. Make sure ON is displayed next to the minutes. If "ON" is not showing you can toggle to ON by tapping A. Proceed to your next alarm by tapping B. Note The six (6) alarms operate independently. If month & date of the alarm is set to "--", the alarm will act as a daily alarm (no reset required). Use button A to start and stop the count down timer. [. . . ] Tap button B to go to CHIME (chime is the" 7th Alarm") Tap A to toggle between chime ("ON" and "Bell Symbol") or off ("--" ). D 1) Back Light 2) Set (press and hold) 3) Reload preset timer 4) Fast escape from split/lap display 5) Exit set (set) 4) Fast escape from split/lap display 5) Exit set (set) GUARANTEE This watch is designed to help the wearer to remember his/her medication on time. The manufacturer ROLAND, the apple pro production inc assumes no responsibility whatsoever for any inconvenience or non-compliance to medications in the event the watch fails to function. WARNING: This Operating Instruction is protected by copyright. ©Copyright e-pill, LLC, 2001, 2002, 2003 e-pill®, MeDos and Medose are trademarks owned by ROLAND, the apple pro production inc or by e-pill, LLC ROLAND, the apple pro production inc, covers manufacturing defects for one year from date of purchase. [. . . ]