User manual E-TECH WGUS03 QUICK GUIDE

[. . . ] If you are connecting directly to another wireless network adapter it should be set to `Ad-Hoc'. Check if your wireless network card has received a valid IP address. Windows 98SE/ ME: Click `Start', `run' and type `command'. Windows 2000/ XP: Click `Start', `run' and type `cmd'. [. . . ] Installing the wireless network adapter on Windows 98SE/ ME/ 2000/ XP. Troubleshooting. Package contents One WGUS03 54MBit wireless network adapter. One USB cable. System requirements Support You can find a lot of information including FAQ's and drivers for all E-Tech products on our website: http://www. e-tech. nu AM20070122A Your computer must be running at least Windows 98SE as an operating system. Your computer needs to have one free USB port. In order to be able to use the CD-ROM your computer needs to be equipped with a CD-ROM or DVD drive. Before you begin You will need to install the driver before connecting the wireless adapter. Connect the wireless adapter when the installer software requests you to do so. Installing the wireless network adapter on Windows 98SE/ ME/ 2000/ XP Follow the instructions below to install the driver: 1. Insert the CD-ROM into the CD-ROM or DVD drive. The CD-ROM will start automatically and show the installer screen (see troubleshooting hint 1 if the CD-ROM does not start automatically). Click `Yes' to agree with the license agreement. Select the desired method from the options given then click `Next' to continue. You will use this software to manage your wireless connection. This includes security for the wireless network. Ralink configuration tool The wireless settings will be managed using the software provided by the manufacturer. Microsoft Zero Configuration Tool The wireless settings will be managed by Windows. This option is recommended for users with Windows XP Service Pack 1 or higher. Choose the desired mode for your wireless network and click `Next' to continue. Optimize for WiFi mode This is the default operating mode for your wireless network adapter. This mode is recommended if your router or access point does not support the higher speeds of the performance mode. Optimize for performance mode (TX Burst) This mode further increases the speed of your wireless connection. The connection between your computer and router or access point can be increased by up to 30%. Connect your wireless adapter to your computer when the software requests it. Click `Finish' to end the installation. [. . . ] Select your profile in the `Profile' tab then click the `Activate' button. Click `OK' to close the screen. Configuring the wireless connection Follow the instructions below to configure your wireless connection. Windows XP Service Pack 1 and 2: Starting with Windows XP Service Pack 1 Windows has built-in support for wireless networking. Windows will find your wireless network automatically and will report that through a bubble in the lower-right corner of the screen (near the clock). [. . . ]