User manual EAGLE FISHELITE 640C ADDITIONAL INSTRUCTIONS

[. . . ] 988-0143-871 www. eaglesonar. com FishElite 640c & ® SeaCharter 640cDF Fish-finding Sonars & Mapping GPS ® Installation and Operation Instructions Copyright © 2005 LEI-Eagle All rights reserved. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Eagle Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Eagle® is a registered trademark of LEI. [. . . ] To change other boxes on the Sonar Digital Page, use to select another digital data box and repeat the steps above. If you are satisfied with the displayed data, press EXIT. The big data box at the top of the page can not be customized. Map With Sonar The Map with Sonar mode splits the screen in half, with the map on the left and the sonar chart on the right. This screen option can be found on the Pages Menu under the Map Page category. Full Map Page (left). The Pages Menu with the Map option list (center). Map With Sonar split screen (right). When using the Map with Sonar page, you can switch between the two pages by pressing PAGES|PAGES. You will not be able to zoom in on one page if the other page is active. You will have to switch to the desired page to make adjustments to it. Sonar Simulator This unit has a built-in simulator that lets you use it as if you were on the water. All sonar features and functions are useable. From the Sonar Page, press MENU|MENU| to SONAR SETUP|ENT| to SONAR SIMULATOR|ENT|EXIT. Repeat these steps to turn it off. 78 Main Menu with Sonar Setup command selected (left). Submenu with Sonar Simulator command selected (center). Sonar Simulator menu (right), with simulator turned off (box is unchecked). NOTE: With Simulate Position checked, the simulator will automatically run the GPS simulator, if GPS data was recorded with the sonar log. To use the default sonar chart log stored in the unit, press ENT|EXIT. The recorded chart begins scrolling across the screen, just as if you were on the water. To turn off the simulator, repeat Step 1. Title bar with chart file name Play symbol flashing Sonar Page playing a recorded sonar chart in Sonar Simulator mode. Tip: The Sonar Simulator can use sonar charts recorded on an MMC card. To play back a sonar chart, install the MMC containing the chart. Press MENU|MENU| to SONAR SETUP|ENT| to SONAR SIMULATOR|ENT. Press or to select chart name|ENT| to SONAR SIMULATOR ON|ENT|EXIT. While you are in the Sonar Simulator menu, do not forget to check Simulate Position if you want to run the sonar and GPS simulators simultaneously. As you review sonar logs, you can create waypoints at sites you want to revisit. While the simulator is running, you can switch from one chart log to another by opening the Sonar Simulator menu and using the instructions in steps 2 and 3 to select a different chart. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-661-3983 905-629-1614 (not toll-free) 8 a. m. [. . . ]