User manual EAGLE SEACHARTER 320DF Operation Instruction

[. . . ] 988-0143-672 www. eaglesonar. com Fish-finding Sonars & Mapping GPS FishElite 320 and SeaCharter 320DF Installation and Operation Instructions Copyright © 2003 Eagle Electronics All rights reserved. Eagle® is a registered trademark of Eagle Electronics Marine-Tex is a trademark of Illinois Tool Works Inc. Points of Interest Data in this unit are by infoUSA, copyright 2001-2002, All Rights Reserved. infoUSA is a trademark of infoUSA, Inc. eXitSource Database, copyright 2001-2002 Zenrin Co. Exit Authority and eXitSource are trademarks of Zenrin Co. [. . . ] When the selected window title bar flashes, press ENT| or to select data type|ENT. Repeat these steps until you're finished customizing, then press EXIT to return to the Sonar Page. Map With Sonar Split Screen There is a page mode that splits the screen in half, with the map on the left and the sonar on the right. This screen option can be found on the Pages Menu under the Map Page category. Map With Sonar split screen option. At far right, the full Map Page is shown. The Pages Menu with the Map option list is shown in the center. At right, the Map With Sonar split screen is shown. When this screen is activated, you need to specify which side the Menu, Zoom In and Zoom Out keys correspond to. The window with the black title bar at the top of the screen is the active window. To switch back, just press PAGES|PAGES again. 81 Sonar Simulator This unit has a built-in simulator that lets you run it as if you were on the water. All sonar features and functions are useable. When in simulator mode, you will see the chart file name in the Sonar Page title bar and a play symbol will flash on and off at the right end of the title bar. From the Sonar Page, press MENU|MENU| to SONAR SETUP|ENT| to SONAR SIMULATOR|ENT. At left, Main Menu with Sonar Setup command selected. Center, submenu with Sonar Simulator command selected. At right, Sonar Simulator menu, with simulator turned off (check box is unchecked). NOTE: With Simulate Position checked, the simulator will also automatically run the GPS simulator (if GPS data was recorded with the sonar log). To use the default sonar chart log stored in the unit, press ENT|EXIT. The recorded chart begins scrolling across the screen, just as if you were on the water. Turn off Sonar Simulator by pressing MENU|MENU| to SONAR SETUP|ENT| to SONAR SIMULATOR|ENT|ENT|EXIT. Title bar with chart file name "Play" symbol flashing Sonar Page, playing a recorded sonar chart in Sonar Simulator mode. 82 Tip: The Sonar Simulator can use sonar charts that you or a friend have recorded (logged) on an MMC card. (To see how, read the entry in this section on Log Sonar Chart Data. ) To play back your own sonar chart, make sure the MMC containing the chart is installed, then: 1. Press MENU|MENU| to SONAR SETUP|ENT| to SONAR SIMULATOR|ENT. Press or to select chart name|ENT| to SONAR SIMULATOR ON|ENT|EXIT. While you're in the Sonar Simulator menu, don't forget to check Simulate Position if you want to run the sonar and GPS simulators simultaneously. [. . . ] Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-324-1354 8 a. m. Central Standard Time, M-F Eagle Electronics may find it necessary to change or end our shipping policies, regulations, and special offers at any time. [. . . ]