User manual EAGLE TRANSDUCERS HS WS INSTALLATION INSTRUCTIONS

[. . . ] INSTALLATION INSTRUCTIONS MANUAL MODELS HS-WS, HS-WSPC, AND HS-WSBK TRANSDUCERS TOOLS YOU WILL NEED: TRANSOM MOUNT: 3/8" DRILL with a variety of small bits Two (2) #12 stainless steel screws (to attach bracket to the transom. ) Marine grade caulking compound (to seal screws) SHOOT-THRU-HULL MOUNT: 100 grit sandpaper One package of the either of the following epoxies: Power Poxy®, 1 oz package. Made by: Power Poxy® Adhesives, Inc. or True Value® brand TRUE BOND epoxy or PLASTIC WELDERTM epoxy sold by True Value® stores. or Devcon® brand PLASTIC WELDERTM epoxy. Copyright © 1995 Lowrance Electronics, Inc. [. . . ] Again, check to see if you can move the transducer so it's parallel with the ground. If it doesn't, repeat step 2, but use a different letter until you can place the transducer on the transom correctly. RATCHETS 3. Once you determine the correct position for the ratchets, assemble the transducer as shown at left. Don't tighten the lock nut at this time. NUT METAL WASHER RUBBER WASHERS BOLT METAL WASHER 3 CAUTION!CLAMP THE TRANSDUCER CABLE TO TRANSOM NEAR THE TRANSDUCER. THIS WILL HELP PREVENT THE TRANSDUCER FROM ENTERING THE BOAT IF IT IS KNOCKED OFF AT HIGH SPEED. GOOD LOCATION POOR LOCATION POOR ANGLE GOOD LOCATION 4. Hold the transducer and bracket assembly against the transom. The transducer should be roughly parallel to the ground. The bottom of the transducer bracket should be in line with the bottom of the hull. Don't let the bracket extend below the hull!Mark the center of the slots for the mounting holes. Drill two 5/32" holes in the marked locations for the #10 screws supplied with the transducer. TRANSOM SIDE VIEW 4 5. Remove the transducer from the bracket and re-assemble it with the cable passing through the bracket over the bolt as shown above. Slide the transducer up or down until it's aligned properly on the transom as shown above. Tighten the bracket's mounting screws. Adjust the transducer so that it's parallel to the ground and tighten the lock nut until it touches the flat washer, then add 1/4 turn. If you do, the transducer won't "kick-up" if it strikes an object in the water. Route the transducer cable to the sonar unit. Make certain to leave some slack inthe cable at the transducer as shown above. If possible, route the transducer cable away from other wiring on the boat. Electrical noise from the engine's wiring, bilge pumps, VHF radio wires and cables, and aerators can be picked up by the sonar. Use caution when routing the transducer cable around these wires. [. . . ] Make certain the area is clean, dry, and free of oil or grease, then sand both the inside surface of the hull and the face of the transducer with 100 grit sandpaper. The surface of the hull must be flat so the entire transducer face is in contact with the hull prior to bonding. SPREAD EPOXY HERE SAND THIS SURFACE 2. Follow the instructions on the epoxy package and mix it thoroughly. Do not mix it too fast, as it will cause bubbles to form in the epoxy. [. . . ]