User manual EARLEX LMB110V

[. . . ] NEVER remove the filler cap when unit is boiling - switch off and wait for 5 minutes. Before standing on the frame ensure all screws are tight and the frame is undamaged. Never use outside when raining. G Always disconnect power supply when filling the machine or when not in use. Do not use any caustic cleaners on the tank. [. . . ] Move the steam plate to the section If the steam plate is fitted with a metal swivel joint, tighten hose nut to thread using two spanners. The plate can remain permanently attached to the hose thereafter. To fill the unit, remove the filler cap and fill to the maximum water level as shown on the glass panel at the end of the tank. This must be clean water, preferably hot. Replace the filler cap, connect the mains 3 immediately next to where you have just been working and use a wallpaper scraper to remove the section that has just been steamed. By working in this way you should be able to remove paper continually. You may have to leave the plate against the wall for longer periods with some papers or re-steam if not completely removed. The 230V unit will operate for approximately 1 1/2 hrs and the 110V unit will operate for approximately 3 1/4 hrs before requiring refilling. The water level is shown through the glass level indicator and should not be allowed to fall below minimum. Switch the unit off when this level has been reached. If you require further use of the steamer, ensure unit is switched off and has stopped boiling. Slowly unscrew the cap, any remaining trapped steam will be released from beneath cap. Caution steam is very hot -wear a glove and keep face clear. Refill to the level indicator as before and follow above instructions. YOU MUST NEVER ALLOW THE UNIT TO BOIL DRY. There is a safety thermal cut-out device fitted to the unit. If the unit is allowed to boil dry this will operate and prevent further use. Switch the unit off and allow it to cool for at least 5 minutes, refill with water and then switch on again - the thermal cut-out should automatically re-set. If this has not re-set allow a further cooling period. When you have finished using the unit allow any remaining water to cool and then empty the unit. We recommend flushing the tank out with clean water before storing. NEVER LEAVE WATER IN THE UNIT WHILST BEING STORED. Storage Spools These are designed for easy and compact storage. [. . . ] The tank is guaranteed against corrosion for 3 years. The guarantee is against faulty materials or workmanship. Whilst every possible care is taken by Earlex to ensure that our products leave the factory in good working order, Earlex cannot under any circumstances accept liability for problems or damage caused by their subsequent use. It is the responsibility of the user to ensure that surfaces to be treated, cleaned or stripped are suitable for steam. [. . . ]