User manual EARLEX STREAM WALLPAPER STRIPPER SS76

[. . . ] Switch off and wait for 2 minutes before removing filler cap to refill boiler. G G G G G G G G G G G G Do not overfill the reservoir. Allow to cool completely before emptying boiler. Do not drag or try to move boiler by pulling the mains lead or hose. Do not allow water or steam to enter light switches or power points. [. . . ] Do not leave unattended and keep children & pets out of the room. Just before full steam production a small amount of bubbling and water will occur at the steam plate. Beware of hot water discharge prior to steam emission. 2 W15 03-06. qxd 10/4/07 10:53 am Page 3 STRIPPING: Remember to check a small area first. Operation is simple for both right and left handed people. Simply hold the steam plate flat against the wallpaper for approx. Now move the plate to the spot immediately next to the one just steamed - from which the paper should now easily come away with a little help from a wall scraper. Working this way should enable continuous paper removal although it may be necessary to steam for longer periods with some papers, or if not completely removed first time. If unit requires refilling, unplug cord and allow to cool for at least 2 minutes before removing filler cap - Beware of steam. When finished, allow to cool completely and empty unit. SAFETY CUT-OUT A safety cut-out is fitted to prevent overheating the element if the water boils low. If unit stops boiling during use this may be the cause. Wait for 2 minutes before removing filler cap then re-fill with water. The cut-out will self reset and steam be produced again within 5-15 minutes. The cut-out will not protect the element if a part filled unit is tilted during use in a way which enables part of the element to be out of the water for longer than 15-20 seconds. OTHER USES Artex® Normally Artex® can be removed using the same method as for wallpaper although the steaming time will be longer. CAUTION: Some textured finishes may contain asbestos which may be hazardous to health and which are subject to licensing controls operated by the HSE (Health & Safety Executive). Vinyl Floor Tiles Vinyl floor tiles can also be removed if the plate is left long enough for the heat to penetrate the adhesive. Once the adhesive is hot it softens and the tile can be peeled from the floor. Sterilising Soil To sterilise soil in seed trays or greenhouses rake the soil to obtain a fine surface. Leave the steam plate on each section, for 2 to 2. 5 minutes which should ensure that the steam has penetrated through the surface. Killing Weeds Steam will kill weeds on paths and patios without the use of chemicals. You will need to steam the weeds for 1 to 1. 5 minutes in order to kill them. Killing weeds TROUBLE SHOOTING Unit Fails to Boil The unit has probably not been left for long enough to cool - refer to section on safety cut-out. Check the fuse in the plug is sound and is rated at 13 amps. If using an extension lead check that it is rated at a minimum of 10 amps and it is fully unwound. [. . . ] The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. GUARANTEE This product is guaranteed for a period of 24 months against faulty materials and workmanship. Whilst every possible care is taken by the manufacturer to ensure that our products leave the factory in good working order, we canot under any circumstances accept liability for problems or damage caused by their subsequent use. It is the responsibilty of the user to ensure that surfaces to be cleaned or stripped are suitable for steam. This guarantee does not affect your statutory rights. [. . . ]