User manual EARLEX WD1000

[. . . ] INSTRUCTIONS AND GUARANTEE R COMBIVAC TM MULTI-PURPOSE WET & DRY VACUUM AND BLOWER SYSTEM PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE RETAIN FOR FUTURE REFERENCE SAFETY RULES PLEASE READ BEFORE USE · Do not leave appliance unattended when plugged in. Unplug from outlet when not in use and before servicing and cleaning. · To avoid electric shock, do not expose to rain. · Never pick up inflammable or combustible liquids such as petrol or other volatile substances. [. . . ] When using the vacuum facility fit the swivel connector into the inlet in the side of the recovery tank (see illustration). Fit one of the extension tubes into the other end of the hose, making sure you slide this on as far as possible. If required the second extension tube can now be added and either the floor head or the crevice tool fitted into the end. The cleaner can be used without either of these tools if required. 4 OPERATION 1) Ensure that the motor housing has been clipped onto the base in the correct position, with the air outlet opposite the vacuum inlet hose. Failure to observe this will allow the filter to foul the internal inlet pipe. 2) Unwind the mains lead fully and connect to the mains or extension lead. Beware of discharged air from the outlet on the motor housing. FLOAT SHUT OFF The cleaner is protected by an automatic shut-off float valve when it becomes full of liquid. This will become apparent to you as the motor will start to make a high pitched noise. If this happens: 1) Switch the unit off. 3) Lift the hose up to drain any excess liquid back into the container. 5) Try to keep the hose raised whilst emptying out the liquid, this can help eliminate any spills. WARNING - BE CAREFUL WHEN EMPTYING THE TANK - IT MAY BE HEAVIER THAN YOU THINK. Important The float valve is a safety device, do not attempt to remove this or modify it, it is there for your safety. Should the cleaner overturn during use, switch the unit off immediately, return to the upright position and wait until the float valve has repositioned itself. If collecting soapy water you will need to regularly check whether the unit requires emptying as the lather can bypass the float system and there can be a discharge of foam!Should this occur switch off the unit, wash out any foam in the filter and tip away any water around the outlet on the motor housing, before restarting. EMPTYING TANK WARNING - TAKE CARE, THE TANK MAY BE HEAVIER THAN YOU THINK. 1) Switch off the unit and unplug from the socket. 2) Unclip the motor housing from the recovery tank. 3) Empty tank of all contents - making sure that you are protected against any sharp objects. 5) Check and clean any blockages within the unit. 6) Replace motor housing, plug in and continue as before. BLOWER FUNCTION 1) The CombiVac can be used as a powerful blower by inserting the hose into the outlet on the motor housing. 2) Always ensure that the hose, tank and accessories have been cleaned of any debris before operating the blower function. 3) You should always protect your eyes with safety goggles when using this function and ensure that no one else is in close proximity. [. . . ] SS100 Super Steamer - 2300W 4. 5 ltr steam wallpaper stripper. SS50 Warrior - 2000W 4. 5 ltr steam wallpaper stripper. A range of steam cleaning accessories is also available to be used in conjunction with the steam wallpaper strippers. The accessories can be used to clean and rejuvenate carpets, floor tiles, unblock sinks or waste outlets, clean work surfaces, defrost fridges and freezers, clean windows and tiles, remove soiling from upholstery and curtains. [. . . ]