User manual EARLEX WD1200P

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual EARLEX WD1200P. We hope that this EARLEX WD1200P user guide will be useful to you.

Lastmanuals help download the user guide EARLEX WD1200P.


Mode d'emploi EARLEX WD1200P
Download
Manual abstract: user guide EARLEX WD1200P

Detailed instructions for use are in the User's Guide.

[. . . ] INSTRUCTIONS AND GUARANTEE R MULTI-PURPOSE WET & DRY VACUUM AND BLOWER SYSTEM PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE RETAIN FOR FUTURE REFERENCE SAFETY RULES PLEASE READ BEFORE USE · Do not leave appliance unattended when plugged in. Unplug from outlet when not in use and before servicing and cleaning. · To avoid electric shock, do not expose to rain. · Never pick up inflammable or combustible liquids such as petrol or other volatile substances. [. . . ] Fit one of the extension tubes into the other end of the hose, making sure you slide this on as far as possible. If required the second extension tube can now be added and either the floor head or the crevice tool fitted into the end. The cleaner can be used without either of these tools if required. OPERATION 1) Ensure that the motor housing has been clipped onto the base in the correct position, with the air outlet opposite the vacuum inlet hose. Failure to observe this will allow the filter to foul the internal inlet pipe. 2) Unwind the mains lead fully and connect to the mains or extension lead. 3) The unit has two operating modes - continuous and power take off mode. With the switch set to position I (continuous mode) the vacuum motor will operate all the time that the switch is on. With the switch in position II (power take off mode) the operation of the vacuum motor is controlled by a power tool plugged into the socket on the back of the unit. When the power tool is switched on there is a delay of approximately 5 seconds before the vacuum motor switches on. When the power tool is switched off there is a delay of approximately 7 seconds before the vacuum motor switches off. 4 FLOAT SHUT OFF The cleaner is protected by an automatic shut-off float valve when it becomes full of liquid. This will become apparent to you as the motor will start to make a high pitched noise. If this happens: 1) Switch the unit off. 3) Lift the hose up to drain any excess liquid back into the container. 5) Try to keep the hose raised whilst emptying out the liquid, this can help eliminate any spills. WARNING - BE CAREFUL WHEN EMPTYING THE TANK - IT MAY BE HEAVIER THAN YOU THINK. Important The float valve is a safety device, do not attempt to remove this or modify it, it is there for your safety. Should the cleaner overturn during use, switch the unit off immediately, return to the upright position and wait until the float valve has repositioned itself. If collecting soapy water you will need to regularly check whether the unit requires emptying as the lather can bypass the float system and there can be a discharge of foam!Should this occur switch off the unit, wash out any foam in the filter and tip away any water around the outlet on the motor housing, before restarting. EMPTYING TANK WARNING - TAKE CARE, THE TANK MAY BE HEAVIER THAN YOU THINK. 1) Switch off the unit and unplug from the socket. 2) Unclip the motor housing from the recovery tank. 3) Empty tank of all contents - making sure that you are protected against any sharp objects. 5) Check and clean any blockages within the unit. 6) Replace motor housing, plug in and continue as before. BLOWER FUNCTION 1) The CombiPowerVac can be used as a powerful blower by inserting the hose into the outlet on the motor housing. [. . . ] The wire which is coloured brown must be connected to the terminal which is marked with the lettter L or coloured red. 7 OTHER PRODUCTS FROM EARLEX Earlex also manufacture a wide range of steam wallpaper strippers and other decorative power tools to help in your DIY efforts. STEAM WALLPAPER STRIPPERS Designed to remove all types of wallpaper, multi-layered painted papers and Artex. SS100 Super Steamer - 2300W 4. 5 ltr steam wallpaper stripper. SS50 Warrior - 2000W 4. 5 ltr steam wallpaper stripper. A range of steam cleaning accessories is also available to be used in conjunction with the steam wallpaper strippers. The accessories can be used to clean and rejuvenate carpets, floor tiles, unblock sinks or waste outlets, clean work surfaces, defrost fridges and freezers, clean windows and tiles, remove soiling from upholstery and curtains. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE EARLEX WD1200P

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual EARLEX WD1200P will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag