User manual EARLEX WDACC18

[. . . ] NEVER spray near a naked flame, including appliance pilot flame. WARNING: The substances used with this spray gun (paint, thinner etc) NEVER smoke whilst spraying. may contain hazardous, harmful, explosive or corrosive materials. NEVER allow children to operate or ALWAYS COMPLY WITH THE SAFETY play with the spray gun. [. . . ] The viscosity cup supplied will help you determine the correct thickness of the paint. Paint is "thinned" by adding the substance which the paint is based upon. If a water based paint then water is added, if oil based then white spirit, if cellulose then a cellulose thinner is added. As some paints, wood preservatives and other sprayable materials contain particles that have differing qualities, please ensure that when filling the paint container of the spray gun, that the paint is filtered through either a funnel with a filter on it or through nylon tights or stockings. This will ensure that no large particles enter the paint container, so preventing blockages and provide you with trouble free spraying. Ensure that a face mask, gloves and goggles are worn at all times when spraying. IDEAL VISCOCITY Water based paints Oil based paints Wood preservatives Primers Varnishes Aluminium paints Wood stains Cellulose 45 - 60 seconds 45 - 50 seconds No dilution 45 - 50 seconds No dilution No dilution No dilution Manufacturers ratio This gun can be used having products with a viscosity ranging from 10 to a maximum of 60 seconds. final. qxd 22/02/00 11:05 Page 5 Dip the viscosity cup into the material and fill up. Time how long it takes for the viscosity cup to empty (Fig 1). Using the above chart (or manufacturer's instructions) as a guide determine if the material requires further thinning, if so then thin accordingly. Combivac hose and the other end into the back of the Spray Gun. ALWAYS KEEP THE COMBIVAC UNIT AS FAR AWAY FROM THE SPRAYING AREA AS POSSIBLE TO PREVENT PAINT CONTAMINATING THE MOTOR. MASK ANY AREA YOU DO NOT WISH TO BE SPRAYED Once you have set up ready to spray, switch on the Combivac. No paint will be sprayed from the gun until the trigger on the Spray Gun is pulled. Before starting any work on spraying actual objects we suggest you spend a small amount of time practicing on cardboard or newspaper until you have got used to how the gun works. Position the fluid tube in the paint container to provide the best angle to pick up all the paint in the container SPRAY PATTERNS Fig. 3 Fig. 1 OPERATION Fill the paint container with the material to be sprayed. Screw the container onto the body tightly. This is designed to fit into the hose supplied with the Combivac to give you sufficient length of hose to be able to spray most objects without limiting the spraying action. Vertical Jet Horizontal Jet Round Jet The gun has both adjustable volume control and 3 different spray patterns ­ Horizontal, Vertical and Round (Fig. 3) The horizontal and vertical are recommended for large surfaces. The round spray is used for small objects or for areas - such as corners ­ that are difficult to reach. To adjust the spray pattern, loosen the adjustment ring (9), adjust the position of the nozzle (8) to obtain either a vertical, horizontal or round pattern then retighten the adjustment ring. 5 Fig. 2 The Combivac hose needs to be fitted to the "Blower" outlet (Fig. 2) ­ this is the outlet at the top of the machine. Connect the additional hose, supplied with the Spray Gun into the end of the final. qxd 22/02/00 11:05 Page 6 PAINT VOLUME The volume of paint sprayed is easily adjustable. (Fig. 4) Fig. 4 Completely close adjustment screw (4) by turning this clockwise as far as it will go. Whilst pulling the trigger, begin turning the adjustment screw anti-clockwise until the volume of paint you require is obtained. If the paint spray is too wide or contains too much paint turn the adjustment screw clockwise again. Once the correct spray pattern is obtained you are able to commence spraying. SPRAYING TECHNIQUE 1. To obtain the best results always keep your spray gun level and spray equally from side to side or up or down 25-30cm (10"-12") from the surface. [. . . ] SC165 - 1500W 4. 5 ltr steam cleaning kit, including carpet cleaner, window/tile cleaner, jet nozzle cleaner, upholstery cleaner/small steam plate, large wallpaper stripping plate. PR9 Autofeed Cordless Painting System - Portable battery operated paint rolling system. It has a 3 litre paint reservoir and 23cm (9") roller and automatically feeds paint to the roller head. Easy to use the PR9 provides enough capacity to apply one coat to a 3. 6m x 2. 7m (12' x 9') room without having to refill. [. . . ]