User manual EBENCH KH 2214 PROJECTION CLOCK WITH RADIO

[. . . ] If the mains cable is damaged, get it replaced by the customer service, before using the instrument again. · Do not place candles or other open fire sources on the appliance. · Use the clock in dry environments only. · Make sure that fluids or any other objects do not get inside the device. [. . . ] Controls TUNING FM/AM (Band selector) VOLUME (volume control) SLEEP (Sleep timer) ALARM Set / Off SNOOZE MIN (LED display) HOUR (LED display) TIME (time setting LED display) µ Function switch ON OFF AUTO BUZZ ¸ Projection On/Off ¹ FOCUS (for projection) HOUR (Projection display) MIN (Projection display) TIME (time setting Projection display) UKW / FM antenna Power cord Frequency scale Display Battery compartment -6- KH2214_2215_2216_IB_UK 12. 07. 2006 16:21 Uhr Seite 7 KH 2214 / 2215 / 2216 6. Setting the clock Separate settings must be made in the clock for the LED and projection displays. a) LED display While you keep the TIME key pressed: Press the HOUR key to set the hours. b) Projection display ¸ Place the PROJECTION switch in the ON position to switch on the projection display. In case of poor lighting, direct the projection beam against a wall or a similar surface. ¹ Adjust the sharpness of the projection display by rotating the small FOCUS wheel. Note: the display is visible only in darkness at a distance of more than approx. If you can see the time display on the projected area clearly. . . while you keep the TIME key pressed: Press the HOUR key to set the hours. The set time is automatically accepted as soon as the TIME button O is released. -7- KH2214_2215_2216_IB_UK 12. 07. 2006 16:21 Uhr Seite 8 KH 2214 / 2215 / 2216 7. Setting the wake-up time If the time for the LED display is set as explained above: while you keep the ALARM Set / Off key pressed: Press the HOUR key to set the hours. Press the MIN key to set the minutes. Note: To improve the reception of radio stations in the UKW/FM frequency range, point the end of the antenna slowly in various directions. When you have found a suitable position for the reception of the set radio station, secure the antenna in this position, e. g. To receive MW/AM radio stations, a fixed receiver antenna is installed in the appliance. For improved reception, alter the position of the appliance in radio mode. 8. Radio reception µ Place the function switch in the ON position. Turn the volume control button VOLUME to a medium position. Select the radio band on the band selector AM/FM. Search the desired transmitter with the help of TUNING control. 9. Setting the alarm You can wake up to the radio or set an alarm sound. Once the time for LED display and the wake-up time have been set as explained above: a) Set the radio alarm Place the volume control button VOLUME at the volume appropriate to wake you up. -8- KH2214_2215_2216_IB_UK 12. 07. 2006 16:21 Uhr Seite 9 KH 2214 / 2215 / 2216 µ Place the function switch in the AUTO position. The LED display shows a point to the bottom left ( bottom right for KH2215 ), as an indicator. b) Set the alarm tone µ Place the function switch in the BUZZ position. [. . . ] Dispose of the device over a registered waste disposal firm or through your communal waste disposal facility. Observe the currently valid regulations. In case of doubt, consult your waste disposal facility. Batteries may not be disposed of with normal domestic waste. [. . . ]