User manual EBENCH KH 2217 PROJECTION CLOCK WITH RADIO

[. . . ] UK KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM · www. kompernass. com ID No. : KH2217-01/07-V3 Projection Clock with Radio KH 2217 Operating instructions KH 2217 ³ ¹ ¸ µ 2^ 2% 2& 2* 2$ 2# 2@ 2!3) 2( KH 2217 3@ 3# 3& 3^ 3% 3( 3$ 3* 4@ 4! 4) Contents Safety instructions Intended use Items supplied Appliance overview Technical data Preparing for use Providing electrical power Using the clock Using the radio Cleaning the appliance Disposing of the appliance Warranty and Service Importer Page 4 6 6 6 8 8 9 10 15 20 20 21 21 Read the operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference. Pass this manual on to whoever might acquire the appliance at a later date. -3- Projection Clock with Radio KH 2217 Safety instructions To avoid fatal injury through electric shock: · Only use the appliance in dry rooms. [. . . ] Within 10 seconds repeatedly press the button 2* MIN+ SET to switch between the 12-hour mode ("12Hr" blinks) and the 24hour mode. Press the button 2@ BAND or wait a few seconds. The selected mode is taken over. In the 12-hour mode the indicator PM appears under the time display for the hours of the afternoon/evening. Setting the alarm time You can programme in two different alarm times, AL1 and AL2. Alarm times can only be programmed with the radio switched off. The button 3) HOUR+ SET can be pressed numerous times in succession or held down firmly. Press the button 3) HOUR+ SET to set the hours. As soon as the desired hour indication is shown in the display for alarm time AL1, release the button. - 11 - The button 2* MIN+ SET can be pressed numerous times in succession or held down firmly. Press the button 2* MIN+ SET, to set the minutes. As soon as the desired minute indication is shown in the display for alarm time AL1, release the button. Press the button 2^ AL1 SET or wait a few seconds. The programmed alarm time will be taken over. To programme in the second alarm time, repeat the steps 1 to 6. However, instead of pressing button 2^ AL1 SET, press the button 2& AL2 SET. Switching the alarm function on Note: If you wish to be woken by the radio, programme in both the desired sound volume and the radio station for the alarm call in advance (see chapter "Adjusting the volume"). With each push on the buttons AL1/VOL+ or AL2/VOL­ you switch through the available alarm options. To switch on the alarm call with signal tone, repeatedly press the button AL1/VOL+ until the bell symbol appears in the field AL1 on the display . The alarm time is shown on the display . The signal tone becomes louder the longer it sounds. - 12 - 2. To switch on the alarm call with radio, repeatedly press the button AL1/ VOL+, until the radio symbol ¹ appears in the field AL1 . The alarm time is shown on the display . To switch off the alarm function, repeatedly press the button AL1/VOL+ until a symbol no longer appears in the field AL1 . The alarm time is nonetheless shown in the display , but the signal tone or radio does not sound at the programmed time. [. . . ] Press the button MEMORY KEY LOCK for ca. In the display the BUTTON LOCK symbol appears. The buttons are locked against inadvertant activation. To cancel the function, press the button MEMORY KEY LOCK for ca. [. . . ]