User manual EBENCH KH 2300 DESIGNER AUDIO UNIT WITH VERTICAL CD PLAYER

[. . . ] The following safety advice must be always followed before using electrical equipment: Please read carefully through the following information concerning safety and proper use. Before reading, fold out the page with the illustrations and make yourself familiar with all the functions of the equipment. Be careful to keep these advice notes and if necessary pass them on to a third party. Do not operate the equipment if the mains plug, cable or the equipment itself is damaged. [. . . ] As soon as the headphones are connected the loudspeakers are turned off. Please note that high levels of sound can lead to serious hearing damage. 01) 02) 03) 04) 05) 06) For you to be able to set the time, the equipment must be in Stand-by mode (operating display R lights up red). Press MEMORY/CLK-ADJ button \ once - the hours display flashes. Move the hours setting forward or backward using the Forward button ) or Reverse button 8. press MEMORY/CLK-ADJ button \ again - the minutes display flashes. Move the minutes setting forward or backward using the Forward button ) or Reverse button 8. Press the MEMORY/CLK-ADJ button \ again - the display stops flashing and the clock starts (the colon flashes). If the Switch-on time feature is enabled then your Designer Audio Unit can wake you at your chosen time. For TUNER (RADIO) set the desired station, for TAPE (CASSETTE RECORDER) insert the tape and wind to the correct place or insert a CD and if required program a track sequence. NOTE: You have five seconds to complete the following steps. Otherwise the process is halted and you must begin again with step 4. 05) Press the MEMORY/CLK-ADJ button \ once - the hours display flashes. 06) Move the hours setting forward or backward using the Forward button ) or Reverse button 8. 07) Press MEMORY/CLK-ADJ button \ again - the minutes display flashes. 08) Move the minutes setting forward or backward using the Forward button ) or Reverse button 8. If you enable the Switch-off time feature, your Designer Audio Unit will always switch off at the set time. NOTE: You have five seconds to complete the following steps. Otherwise the process is halted and you must begin again with step 2. 03) Press the MEMORY/CLK-ADJ button \ once - the hours display flashes. 04) Move the hours setting forward or backward using the Forward button ) or Reverse button 8. 05) Press MEMORY/CLK-ADJ button \ again - the minutes display flashes. [. . . ] pREVIOUS TRACK: The Reverse button 8 jumps backward one track each time it is pressed. FORWARD: Keeping the Forward button ) pressed goes forward within a track. REVERSE: Keeping the Reverse button 8 pressed goes backward within a track. Remove the CD only when movement has stopped completely. [. . . ]