User manual EBENCH KH 2329 INDOOR ANTENNA

[. . . ] Do not allow individuals (including children) to use the appliance whose physical, sensorial or mental abilities or lack of experience and knowledge hinder their safe usage of it if they have not previously been supervised or instructed in its correct usage. Tell children about the appliance and its potential dangers so that they do not play with it. This appliance has been inspected and approved in reference to its conformity with the principal requirements and relevant regulations contained in the EMC Directive, 2004/108/EG, as well as the Directive for Low Voltage Appliances, 2006/95/EG. Ensure that the electrical specifications given on the model plate tally with the rating of the existing domestic electricity supply. [. . . ] the indoor antenna has to be positioned correctly for the proper reception of programme signals. The following antennas are available for this: 1 two telescoping antennas for VHF and UKW reception that tilt and rotate by 180° and 2 one oval-shaped antenna for UHF reception that tilts and rotates by 100°. When you want to use the room antenna for radio reception, utilise the Adapter Coaxial socket/Coaxial socket 8. connect the Adapter Coaxial socket/Coaxial socket 8 with the antenna cable. Connect the anntenna cable with Adapter Coaxial socket/Coaxial socket 8 to the 75 Ohm connector on your stereo system. Pull out both telescopic antenna 1 and adjust these until the best reception is obtained. Adjust the oval antenna 2 by turning or tilting until the best reception is obtained. To connect the room antenna to a DVB-TReceiver with an F-socket, the Adapter F-Plug/ Coaxial socket 7 must be used. connect the Adapter F-Plug/Coaxial socket 7 with the antenna cable. Screw the antenna cable with the Adapter F-Plug/Coaxial socket 7 to the F-socket of the DVB-T-Receivers. You can regulate the amplifier gain by turning the regulator 4 on the front of the appliance: Switch on the indoor antenna by turning the regulator 4 to the right. Turn the regulator 4 completely to the left until it clicks to switch off the indoor antenna. Reception disruptions, such as an unclear or distorted picture could have the following causes: · For this reason, reorient the indoor antenna every time after changing the station. Try to eliminate the interference if, for example, it is caused by other appliances (mobile telephone, micro-wave, etc. Try to eliminate the interference by reducing the amplifier gain by turning the regulator 4 anti-clockwise. The reception characteristics of the indoor antenna are only good if you are close enough to the broad-casting station. Before cleaning, always pull the plug out of the plug socket. Never submerge the indoor antenna into water or other liquids during cleaning. [. . . ] The warranty covers only claims for material and manufacturing defects, not for wearing parts or for damage to fragile components. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. Your statutory rights are not restricted in any way by this warranty. [. . . ]