User manual EBENCH KH 2341 DESIGNER AUDIO UNIT WITH CD PLAYER

[. . . ] Mini-Design-Anlage mit CD-Spieler Designer Audio Unit with CD player Impianto Mini-Design con CD-Player The following pictograms/symbols are used in these operating instructions: Before reading, fold out the page with the illustrations and make yourself familiar with all the functions of the equipment. Only compact discs with this mark are to be used. This device also plays recordable (CD-R) and rewritable compact discs (CDRW). However, due to the varying characteristics of the different recording platforms (PC, special recording devices) in use, it may be the case that CD-R and CD-RW cannot be read. [. . . ] Insert the mains plug into the mains socket and move the switch into position "I". The device is now ready for operation and can be switched on and off (Stand-By) using the button W on the front of the device. Insert the mains plug into the mains socket and move the switch into position "I". The device is now ready for operation and can be switched on and off (Stand-By) using the button W on the front of the device. If you switch the power supply off at the main switch then any stored data such as time and radio presets will be lost. When the power supply is switched on at the main switch (position I), the device goes into Stand-By mode. Press the ON/OFF switch (Stand-By) button W again to switch off the device. If the device is not to be used for an extended period, pull the mains plug out of the mains socket. The Display briefly shows "VOL ON" and then changes back to the last operating mode (e. The functions of the buttons on the remote control handset are identical with those on the device. the maximum range of the remote control signal is about 5 metres. A strong light source in the room may adversely affect the remote control functions. ­ Open the battery compartment in the back of the remote control handset as described there and remove the discharged battery ­ Insert the new battery, making sure that the polarity is correct (+ pole of the battery points upwards) ­ Close the battery compartment again Avoid pressing more than one function button at a time as otherwise this could reduce the service life of your handset. If the handset is not to be used for an extended period, remove the battery from the battery compartment. Use the tone selector button q to set the tone quality of a track to suit the type of music and increase listening pleasure. the current setting Rock/Jazz/Classic/Pop is shown in the display R (FLAT = neutral tone). Note: On model KH 2341, the Tone can be selected only using the remote control handset. 8-32 Ohm stereo headphones A can be connected to the headphones connector with a 3. As soon as the headphones are connected the loudspeakers are turned off. Please note that high levels of sound can lead to serious hearing damage. You can adjust the volume by using the Volume control or the appropriate button on the remote control handset. The Mute setting can be activated from the handset only. [. . . ] If the device is used improperly then this light can be dangerous to the eyes - never open the case. Press button Y again as appropriate, to switch between VHF (FM) and MW (AM). The motorised CD compartment Q can only be opened if the device has been switched on and set in CD mode. Place a CD into the compartment (the label must face upwards). [. . . ]