User manual EBODE IR LINK MINI

[. . . ] Young children should use the device only under adult supervision. No guarantee or liability will be accepted for any damage caused due to incorrect use of the equipment supplied, other than indicated in this owner’s manual. SAFETY WARNINGS • • • • To prevent short circuits, this product (except if specified for outdoor use) should only be used inside and only in dry spaces. [. . . ] How does the ebode IR Link Pro Mini work?The ebode IR Link Pro Mini is intended for use in IR control systems where the IRHUB4 Connecting Hub is within reach of the 3-meter cable of the IRLPRO IR Receiver, e. When installing the IR Link Pro Mini in a cabinet where the controlled components are behind closed doors, and the IRLPRO Mini Receiver can be positioned outside of the cabinet, for instance close or attached to your flat panel, but always within line of sight of your hand held remotes 5. Installing the ebode IR Link Pro Mini The IRHUB4 sockets are colour coded for easy plug & play installation of the IR Receiver and IRED Emitters, which have coloured jacks. Refer to this diagram and the procedure that follows when making connections: Fig 1 31-12-2010 4 IR Link Pro Mini 1. Attach the 3IREDB Emitters onto the IR Sensor Windows of the components in your system that you wish to control. Plug the yellow mini plugs of the 3IREDB into one of the yellow labelled "EMITTERS" jacks of the IRHUB4 Connecting Hub. Plug the IRQC cable into one of the yellow labelled “EMITTERS” jacks of the IRHUB4, and the other side into the 3. Position the IRLPRO Mini IR Receiver in a location outside of the equipment cabinet or closet that will have a straight line-of-sight view of your Hand Held Remote(s). The Receiver can be fixed to the surface by using the double side tape pad. Plug the red mini-plug of the IRLPRO Mini IR Receiver into the red labelled "IR RCVR" jack on the IRHUB4 Connecting Hub. Plug the 12VDC Power Supply into an unswitched 230V~50Hz outlet. NOTE: It is important that you use an unswitched AC outlet so that the IR system is always active for system power ON commands. 1mm "C" plug of the Power Supply Adapter into the "+12VDC" jack on the IRHUB4 Connecting Hub. STATUS You can send a Power Status signal to the IRLPRO Mini IR Receiver by connecting a power adapter to this connection (not supplied), which e. When the A/V device or contact is switched on, the Amber Status LED will light up in the IRLPRO Mini IR Receiver so that you can see that the A/V device is switched on. Fig 2 Fig 3 31-12-2010 5 IR Link Pro Mini On the top of the IRHUB4 cabinet there is a cut out for jumper placement. The default position of the jumper is the parking position JP1. [. . . ] Upp till sex IRLPRO Mini IR-mottagare kan anslutas parallellt till skruvterminalingångarna på IR Link IRHUB-seriens anslutningsmoduler (t. Kabelspecifikationer för längre kabel till angränsande rum: 3-ledare, 24AWG/0, 2 mm 2 solid eller platt kabel upp till 50 m, 22AWG/0, 35 mm2 upp till 100 m, 20AWG/0, 5 mm2 upp till 200 m och 18AWG/1 mm2 upp till 300 m (oskyddad OK). User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste Electric and Electronic Equipment (WEEE) This document contains important information for users with regards to the proper disposal and recycling of ebode products. [. . . ]