User manual ECLIPSE 316SW

[. . . ] CAUTION for customers who concerned TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT FULLY INSERT. CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. 1. 2. 3. 4. 5. Read instructions All safety and operating instructions should be read before operating unit. Follow instructions All operating and other instructions should be followed. Retain instructions The safety and operating instructions should be retained for future reference. [. . . ] Pulling on the cord can damage it and cause fire or electric shock. Do not touch the power cord with wet hands. Do not place the power cord near heating equipment and do not use the unit. If the plug fits loosely in an electric outlet or the plug or cord is hot. If the cord is damaged replace it as continued use may result in fire or electric shock. Unit plug Insert the plug into an outlet all the may to its 12. 13. 14. 15. 16. base. Incomplete insertion can cause heat production, and dust build-up can cause fire. Contact with the prongs of the plug can also cause electric shock. Do not connect the unit to an outlet where the connection is loose even when the plug is inserted all the way to its base. If dust or metal accumulates on or near the prongs of the plug, wipe the plug with a dry cloth after disconnection. Continued use may cause fire or electric shock. Danger signs If you notice a strange noise, smoke, unusual odour or other abnormal condition, shut off the unit, disconnect the power cord from the outlet and have the unit inspected. Continued use may result in fire or electric shock. Electric storms During electrical storms disconnect the unit and avoid contact with the antenna and power cord. Lightning can cause fire, electric shock and malfunction. Internal temperature rise To avoid internal temperature rise when installing the unit, leave space between the unit and walls or other equipments. When installed in a rack or similar fixture, leave a 10cm (4") or larger gap on top and at sides since internal temperature rise can result in fire. The unit is provided with ventilation holes to prevent internal temperature rise. Blockage of these holes decreases ventilation and can result in fire. Note the following: Do not place the unit in a poorly ventilated area Do not place the unit on carpeting or on bedding Do not obstruct the ventilation holes Do not tilt the unit or turn upside down Extended non-use If the unit is likely to be unused for an extended period, shut off power and disconnect from power supply. Volume Adjustment If abnormal noise is produced during play at high volume, reduce the volume level. Distorted sound can cause overheating of speakers and amplifier. [. . . ] (The power indicator will change from red to blue. ) If this unit is used for signals at extremely low volumes, set this switch to OFF to prevent incorrect operation. Phase select switch This switch is used to select the speaker phase. The ambience of the sound being listened to may change when the position of this switch is changed. The effects will change depending on the main speaker combination being used and on the setting-up environment, so listen to the sound being played back and select the switch setting that provides the most natural playback. When you change a switch , please make volume small for noise prevention. Power switch This switch turns the power on and off. LINE IN terminal This terminal is used to input signals that are output from the LINE OUT terminal of a subwoofer (super woofer) of an AV amplifier or directly from an amplifier. LINE OUT terminal This terminal outputs the signals that are input to the terminal in 6. [. . . ]