User manual ECLIPSE BEC105 INSTALLATION

[. . . ] · Do not install this product in locations where it may interfere with the operation of the steering wheel, shift lever, brake pedal, etc. Otherwise, an accident or injury may result. · To prevent damage to the vehicle, confirm the locations of hoses, electrical wiring, and the fuel tank prior to drilling holes to install this product. Also, take care so that the product does not interfere and/or not come in contact with them. [. . . ] · Be careful not to allow the cable to touch threaded parts of the camera and moving parts such as seat rails when routing them, otherwise the cable may become damaged and shortcircuits may occur which could result in fire, electric shocks or other accidents. Points to note after installing the rear camer a - Method of use · Do not place too much reliance on the back-eye camera. · The backeye camera is meant to be used as a supplementary aid to help in avoiding obstructions. · If the lens is obscured by raindrops or similar, it may reduce in the effectiveness of the camera. · The position of the images displayed on the screen will vary depending on the vehicle conditions (such as number of passengers and laden weight). Be sure to check for safety behind and around the vehicle while driving. · Never reverse the vehicle while watching only the images produced by the camera. Be sure to use the interior mirror and door mirrors also to check for safety behind and around the vehicle. · The characteristics of the camera lens will make all obstructions on the screen appear differently from their actual positions and distances. - Handling · Do not subject the camera to strong shocks by hitting it firmly or knocking it against other objects. If this is not observed, it may damage the camera or cause problems with operation. · Do not subject the camera lens to naked flames or sudden changes in temperature (example, "hair dryer") or hot water, otherwise it may damage the camera or cause problems with operation. · Avoid using in direct sunlight for long periods of time. If this is not observed, burn-in of images may occur. · The initial image that is displayed from the rear of the vehicle will be a white image (it may vary depending on the model of camera connected), but the image will gradually stabilize. · If the camera is used for long periods of time, the increase in temperature may cause white marks or horizontal lines to appear. This is a characteristic of the CCD and is normal. · Flickering may occur in the images if the camera is used underneath fluorescent light in 50 Hz power supply areas. This is normal and is not the sign of a malfunction. · Do not clean the backeye camera unit and lens, the bracket, or the camera cable with volatile chemicals such as alcohol, kerosene, thinner or gasoline. Using such chemicals may cause warping, discoloration or other damage. · Do not use cleaning substances that contain abrasive powders. Using such substances will damage the camera. · If the lens area becomes dirty, wipe it gently with a soft cloth moistened with water. [. . . ] Loosen the adjustment screw and adjust the angle of the camera so that the rear of the vehicle (rear window, back door, rear bumper, etc. ) are visible as shown in the diagram. Rear of vehicle 4 After adjusting the angle, securely tighten the adjustment screw. At this time, secure the bracket adjustment screw so that it is at either end of the slot in the bracket. - Angle adjustment 1 Rear camera Tip · Prior to adjusting the rear camera angle, 3 Screw (M3x6) check that gear was shifted into Park or Neutral position. · Be careful not to pull on the cable when adjusting the angle of the rear camera. [. . . ]