User manual ECLIPSE DCU105 INSTALLATION

[. . . ] · Do not install this product in locations where it may interfere with the operation of the steering wheel, shift lever, brake pedal, etc. Otherwise, an accident or injury may result. · To prevent damage to the vehicle, confirm the locations of hoses, electrical wiring, and the fuel tank prior to drilling holes to install this product. [. . . ] Otherwise, an injury such as loss of eyesight may result. · Exposed wires must be insulated with electrical tape. Otherwise, a short circuit, fire, or electric shock may result. · Do not modify this system for use other than that specified herein. Also, do not deviate from the installation procedures described herein; Eclipse will not be held liable for damages including, but not limited to serious injury, death or property damage resulting from installations that enable unintended operation. -3- · For best results, this product should be installed by a professional installer. Contact the dealer whom you purchased the product for an appointment. · When installing this product, be sure to use the supplied mounting hardware. If parts other than those supplied are used, the unit may be damaged internally, or may not be held in place securely and become dislodged. · Avoid installing this product in places where it may get wet, such as near windows, or in places that are moist, damp, or dusty. Presence of liquid, moisture, or dust inside this product can cause short circuiting resulting in smoke and / or fire. · If this product is not connected properly, a short circuit, fire, and / or accident may occur. · When routing cables, use care so that they do not contact sharp metal parts such as brackets or screw tips. Otherwise, a short circuit, electric shock, fire and / or accident may result. · Play the audio at a moderate volume level that permits you to hear sounds from outside the vehicle. Driving with the inability to not hear outside sounds may result in an accident. [. . . ] (Refer to the instruction manual for details on switching the speaker layout. ) · If the speaker layout is "1-way speaker": Use the "LINE OUT" (Front/Front/Mid) terminal C . · If the speaker layout is "3-way speaker": Connect B to the low-range speaker (woofer), connect C to the mid-range speaker (squawker), and connect D to the high-range speaker (tweeter). · · · E Line-out terminal (Rear) Connect to the RCA input Connectors of an external amplifier. White : Left signal Red : Right signal -6- F Center speaker line-out terminal If using a center speaker (sold separately ), connect it to the RCA input connector of an external amplifier. G Woofer speaker line-out terminal If using a woofer speaker (sold separately ), connect it here. H I VTR input terminals (CH1) VTR input terminals (CH2) Connect the output cable of external video equipment sach as a VTR. [. . . ]