User manual ECLIPSE ECLIPSE TD BROCHURE

[. . . ] Be particularly careful when using the unit in rainy weather or when it is snowing, at the beach or near water. Do not place above or near the unit, any flower vases, plant pots, cups, makeup, medicine or any vessel containing liquid or any small metal objects. In case any liquid or small metal objects enter the unit, fire or electric shock may result. Do not push or drop any metal or combustible objects into the ventilation holes of this unit. [. . . ] (Be particularly cautious in households with young children). CAUTION Do not use the stand to support any other item. The mounting may become unstable, resulting in a fall, causing injury. This unit should be assembled on a flat, even surface. Failure to do so may cause the stand to fall over leading to injury. Avoid placing the stand where it may obstruct free passage. The unit should be placed on a hard, flat surface. Placing the unit on an unstable surface may cause it to fall over and cause injury. In particular, care should be exercised when children are present. The unit may fall or break and cause injury. The unit is heavy so always use two people to unpack and carry the unit. Using the hexagonal wrench with the hexagonal socket head bolts and washers, fasten the speaker to the stand (3 places). ADVICE Fasten the hexagonal socket head bolts by hand first before using the hexagonal wrench to fasten them securely. To secure the speaker, first tighten the two rear bolts, then tighten the front bolt. You must use the attached hexagonal socket head bolts (x 3) to fasten the speaker. The washers must be used with the convex side facing down. Feet adjustment As shown in the diagram, turn the feet to adjust. ADVICE Feet Initially, turn the four feet in an anti-clockwise direction as far as they will go and place the unit on the floor. Then, turn each foot individually in a clockwise direction until they touch the bottom foot ­ then stop. 3 Setting the angle adjustment screw at 0 degrees Template Angle adjustment screw ADVICE When adjusting the speaker angle, follow these instructions and start from a 0 degrees position. Template 4 Adjusting the speaker angle Using the hexagonal wrench, loosen the hexagonal socket head bolts (3 places). Using the hexagonal wrench, turn the angle adjustment screw. When finished, use the hexagonal wrench to tighten the hexagonal socket head bolts. To secure the speaker, first tighten the two rear bolts, then tighten the front bolt. Upward adjustment Hexagonal wrench ADVICE When the top surface of the stand and the bottom surface of the speaker are flush, they should be level. It is possible to adjust the speaker upwards by 10 degrees. Angle adjustment screw 5 Installation of protective cover. As shown in the diagram, install the protective cover. ADVICE The protective cover may be attached when the speaker is not in use or at the user s discretion. Maintenance / Specifications Maintenance Before maintaining the unit, ensure that the power is off and the power cord removed. Remove any dirt from the unit by lightly wiping with a soft cloth. [. . . ] Remove any dirt from the unit by lightly wiping with a soft cloth. If it is particularly dirty, use a slightly damp cloth to wipe it down, then use a dry cloth. on this unit as it may damage the cabinet. Specifications Specifications and appearance are subject to change without prior notification. ·oe TD712z Diameter: Type: Input Resistance: Impedance: Dimensions: Weight: 12cm Bass ref/box Rated 35W / Maximum 70W 6 347mm(W)x384mm(D)x988mm(H) 32kg Gasoline Thinner Problems during Operation of the Unit During operation, the unit may stop working properly if it suffers from significant external disruption (impact shock, static electricity, voltage fluctuation caused by lightning, etc. ) or is operated incorrectly. [. . . ]