User manual EDIROL VC-50HD

[. . . ] Owner's Manual Before using this unit, carefully read the sections entitled: "USING THE UNIT SAFELY" and "IMPORTANT NOTES" (p. These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner's Manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference. Copyright © 2009 ROLAND CORPORATION All rights reserved. [. . . ] HD/SD-SDI input connector and indicator This connector allows SDI signals to be input . Connect it to the SDI output connector of your camera or deck. If an input signal is present, the indicator will light in one of the following colors. If there is no input, the indicator will blink. · HD-SDI (1080i) : green · HD-SDI (720p) : orange · SD-SDI : red If the Edirol F-1 (version 2 or later) is connected as the output destination device, you'll be able to edit the VC-50HD's settings via remote control from the F-1. 2. HD/SD-SDI output/thru out connector This connector outputs an SDI signal. Connect this to the SDI input connector of your deck or other video recording device. You can also use this as a thru-out for the SDI signal that is being input to the VC-50HD, in order to send ("thru-out") this signal to a video mixer or similar device. Carefully check the shape of the IEEE 1394 connector before connecting it. Connecting it in the reversed orientation may damage components inside the VC-50HD, causing malfunctions. 4. HDMI output connector Connect this to a monitor device that has an HDMI input, such as a television or computer display. 3. IEEE 1394 connector and indicator This connector inputs and outputs an HDV/ DV or other signal via IEEE 1394. Connect it to the IEEE 1394 (i. LINK) connector of your camera, deck, or computer. If input is present, the indicator will light in one of the following colors. If there is no input, the indicator will blink. · HDV/MPEG-2 TS : green · DV : red 5. POWER indicator This indicator will light when the VC-50HD is powered up. * This indicator will blink if the AA batteries run low. If this begins blinking, replace the batteries as soon as possible. 12 Names of things and what they do Side panel 1 2 3 4 1. USB connector This can be connected to your computer, allowing the VC-50HD's settings to be switched via remote control. For the remote control software, please refer to the following Roland website. http://www. rolandsystemsgroup. net/ * When shipped from the factory, these switches are set as follows. All OFF 2. Mode select switches These switches allow you to switch the VC50HD's input/output mode and control mode. Use a fine-pointed pen or similar object to change the setting of a switch. [. . . ] Use the POWER switch to turn the power on/off. 28 Appendices Troubleshooting If you suspect a malfunction, please check the following points before you contact us. If this does not solve the problem, please contact a Roland customer service center. Can't turn off the power · Could mode select switch 6 be turned ON?If this is ON, the power will turn off when you disconnect the power cable supply (p. 28). Power turns on even though you don't operate the POWER switch · Could mode select switch 6 be turned ON? [. . . ]