User manual EDOBE XDOM EM

[. . . ] Voltages in this equipment are hazardous to life. Important: the product must be used according the instructions in this manual and is not suitable for other purposes. Please avoid the following: strong mechanical wear and tear, high temperature, strong vibrations, and high humidity. [. . . ] Configuring the Unit Code Press and release the ON key the appropriate number of times for the Unit Code you want to set. The factory setting will be "1 = 1 Green Blink" After setting the UNIT Code, the yellow LED blink 3 times, which means the Unit Code is set and the module has leave the program mode. Use a screwdriver to remove the mounting plate from the switch cover. When changing the battery, the address will be retained. : for B3 the red led will blink 2 times for the house code and the green led will blink 3 times for the unit code. Wait until the yellow led blinks 3 times to indicate the module has left the program mode. Short press on the ON button, receivers with the same address will power on or open (when used with shutter). Short press on the OFF button, receivers with the same address will power off or close (when used with shutter). EM transmitter for centralised master control RMV Receivers located on the ground floor Place at the door entrance EM Transmitter to control the ground floor as a group EM Transmitter to control the first floor as a group Receivers do not respond to wall switch command?Viktigt: När du fäster reglaget, se alltid till att ebode loggan sitter nere till höger. Ront LED lampan indikerar följande 3 lägen: - Röd LED: Huskod (A till P) - Grön LED: Enhetskod (1 till 16) - Gul LED: status för programmerat läge. Se till så att ebode loggan är nere till höger. Dès maintenant commander à distance (récepteur réglé sur la voie A1): a) Les récepteurs RMA, RMV, RPT, RPA, RPL (rappel : les récepteurs RPA et RPL nécessite la présence d'un convertisseur d'ordre radio vers courant porteur). CE DECLARATION OF CONFORMITY UK - We, BMB Electronics BV, Kortakker 10 ­ 4264 AE Veen ­ The Netherlands, herewith declare that the following designated product EM, is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. [. . . ] Control your appliance or lamps etc, via any ebode or X10 compatible controller via PLC AND RF!New stylish RF remote to control any ebode or X10 compatible RF receiver. In-Wall Modules Product EMML RMML PMML Description 2-position RF in-wall module to install behind any mechanical wall switch. [. . . ]