User manual EDOBE XDOM IR LINK PRO

[. . . ] Do not expose the components to rain or humidity. Avoid strong mechanical tear and wear, extreme ambient temperatures, strong vibrations and atmospheric humidity. [. . . ] The ebode IR Link Pro is intended for use in IR control systems where the IRHUB2 Connecting Block is within reach of the 2-meter cable of the IRLPRO IR Receiver, e. When installing the IR Link Pro in a cabinet where the controlled components are behind closed doors, and the IRLPRO Receiver can be located on top of the cabinet, within line of sight of your remote control. Installing the ebode IR Link Pro The Hub sockets are colour coded for easy plug & play installation of the IR Receiver and IRED Emitters, which have coloured jacks. Refer to this diagram and the procedure that follows when making connections: Attach the 3IREDB Emitters onto the IR Sensor Windows of the components in your system that you wish to control. Plug the yellow mini plugs of the 3IREDB into one of the yellow labelled "EMITTERS" jacks of the IRHUB2 Connecting Block. Plug the IRQC cable into one of the yellow labelled "EMITTERS" jacks of the IRHUB2, and the other side into the 3. Locate the IRLPRO IR Receiver in a location outside of the equipment cabinet or closet that will have a straight line-of-sight view of your Hand Held Remote(s). The Receiver can be fixed to the surface by using the double side tape pad or via a slide on screw hole on the bottom of the unit. NOTE: It is important that you use an unswitched AC outlet so that the IR system is always active for system power ON commands. STATUS You can send a Power Status signal to the IRLPRO IR Receiver by connecting a power adapter to this connection (not supplied; 5 - 12VDC), which e. When the A/V device or contact is switched on, the Amber Status LED will light up in the IRLPRO IR Receiver so that you can see that the A/V device is switched on. Operation The IR repeater system should now operate each of the controlled components. When the system is operating correctly, you should see a Blue "talk-back" LED flash on the front of the IRLPRO IR Receiver when you aim your hand held remote control(s) at it and press the buttons. How to avoid and solve possible problems Although the ebode IR Link Pro is equipped with proprietary eIR2xTM (pronounced Irex) Technology, which guarantees a high level of immunity of InfraRed noise from direct sunlight, CFL lighting and Flat Panel TV's (including Plasma, LCD and LED), in rare cases, the IRLP IR Receiver may have to be moved to a different location if the unit is picking up unexpected interference. [. . . ] DECLARATION OF CONFORMITY Hereby, ebode electronics, declares that this ebode IR Link Pro is in compliance with the essential requirements and other relevant provisions of the following Directives: Directive 2004/108/EC of the European Parliament and of the Council of 15 December 2004 on the approximation of the laws of the Member States relating to electromagnetic compatibility Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonization of the laws of Member States relating to electrical equipment designed for use within certain voltage limits Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment Directive 2005/32/EC of the European Parliament and of the Council of 6 July 2005 establishing a framework for the setting of eco design requirements for energy-using Technical data and copies of the original Declaration of Conformity are available and can be obtained from ebode electronics: PB 25, NL-4264ZG, the Netherlands. User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste Electric and Electronic Equipment (WEEE) This document contains important information for users with regards to the proper disposal and recycling of ebode products. [. . . ]