User manual EDOBE XDOM RMA

[. . . ] CONNECTING BLOCK Connect all wires as indicated (refer to wiring diagram 1) How to connect Live + Neutral Input L : stands for input Live 230V - 50 Hz N : stands for input Neutral 230V - 50Hz Wiring up Live + Neutral outputs N : Neutral C : (do not connect, only Ph for low voltage) Schematic 1 How to instal wall mount switch. Gently take off paddle from wall switch. Wire up Wall Switch within wall insert box, then fix receiver along with provided screws against wall insert box. [. . . ] This procedure consists of erasing all addresses you may entered over time which are not valid to control your Home Automation system. Press and keep pressed the key PROG till LED lights up green (after 3 seconds). Both green and red LEDS blinks quickly on, to turn of after after several seconds (LED to blink orange). Time to rease depends on the number of entered valid addresses. All addresses are now erased, receiver goes back as well in X10 standard comunication protocol. Put on again the paddle (make sure ebode log is located on the bottom right side). Gently press the upper key (ON) to turn on the appliance/light. Gently press the lower key (OFF) to turn of the appliance/light. Make use of a remote control, RF wall switch, programmer to check remote control of the appliance, light, etc. Eu RMA cannot be controlled anymore from either an RF or PLC remote/ programmer ? - Check and/or change the battery of your remote. - Go for an overall RESET of the receiver as it may have lost the address due to too many manipulations (starts from point 5), then re-initialize transmitter and receiver both together (starts from point 3). - Red or Green LED blinks randomly even if no remote control is performed : RF or PLC interference may occur (ie Fluo lamps, Reversible A/C, PC monitor) please add either a filter FD10 in the main control panel or a plug in module FM10 to filter the product in cause. Följande procedur är för att lära en (eller till och med fler än en) adress från sändare till RMA mottagaren. [. . . ] Cinema screen via the front panel keys, or remotely via any ebode / X10 compatible controller. Pump via the front panel keys, or remotely via any ebode / X10 compatible controller. Ideal for retro fit installations, the classic X10 plugin module in a new and stylish jacket. [. . . ]