User manual EDOBE XDOM ROCKSPEAKER

[. . . ] Store the battery out of reach of small children. When not using the battery, or not using the device for a prolonged period, remove the battery from the device and store it in a dry place between the temperatures of -20oC and +21oC (-4°F- and +70°F). The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as sunshine, fire or the like. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] An audio zone is any area or group of areas where you want the same audio source playing and want the volume of the speakers to be about the same. If you want an area to have different volume level or play a different set of music then use the two zone option. Please note that there is no right or wrong way to do this, it is simply how you think you want to use your AudioRock system. If you try an option and don't like it, it is easy to change and try another one. NOTE: You have some control over an area being on or off by using the power switch that is on the rear of the AudioRock. Simply turn it off and there will not be any sound in that area. Preparing AudioRock for Installation Please charge your battery for your rock by plugging in the power supply and inserting the battery into the charger. Allow at least 8 hours for the first charge. NOTE: Leaving the battery in the charger for periods longer than 24 hours may reduce battery life. When an uncharged battery is placed in the charger the LED on the front of the charger will shine RED; when charging is complete the LED will turn GREEN. Step 3: Slide battery into the charger making sure that it is inserted correctly and that you do not have to force the battery into the charger. Step 4: When the battery is fully charged the LED on the front of the charger will turn GREEN. Step 5: Remove Battery from charger and place it into the AudioRock. Secure the battery by sliding the tabs over the battery until they are pointing straight at each other. Step 2: Be sure the zone switch on the back of your AudioRock is set to zone 1 unless you are setting up a two zone system. If you intend to set up a two zone system, be certain the zone switch is set to the number corresponding to the zone you intend to place it in. Pairing the AudioRock to the Transmitter Before you can begin using and enjoying your new portable wireless AudioRock system, it is necessary to "teach" your AudioRock the identity of the transmitter you are using; this teaching is called "pairing" and is very easy to do. Step 1: With the Transmitter power on (LED on front will be lit), find and press the pairing button on the back of the unit. You may need a sharp object, like a pen, to press the button in. When you do, you will see the LED on the front of the transmitter flash. This means the unit is in the "pairing" mode. Step 2: Quickly set the power switch, located at the back of your AudioRock, to "ON" and press the pairing button also located on the back of the AudioRock. [. . . ] repair or replacement as provided under this warranty is the exclusive remedy of the consumer/purchaser. Ebode electronics shall not be responsible for any incidental or consequential damages except to the extent provided (or prohibited) by applicable law. Some COUNTRIES do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from COUNTRY TO COUNTRY. [. . . ]