User manual EDOBE XDOM SL18 PRODUCTSHEET

[. . . ] Overdriving your amplifier could also damage your SubWoofer. CARE AND CLEANING Your speakers have a durable finish that should only require dry dusting. avoid use of abrasive or solvent-based cleaners and harsh detergents. The brush attachment of your vacuum or a damp cloth should remove any dust from your speaker grilles. [. . . ] The system can use up to 4 wireless SubWoofers (when used with an ebode LightSpeaker transmitter) to provide bass to your entire living area. Additionally, the system can be expanded by adding our patented LightSpeakers®. These LightSpeakers install in minutes and fit into table lamps, hanging lamps or any standard E27 Edison socket. The LED light provides "green" lighting and the speaker provides outstanding sound throughout your home. The LightSpeakers are available from your retailer or at www. The entire system provides even greater flexibility to you as the owner since you can take it with you if you move. It leaves no trace that the system was ever installed or used. What's in this Box What's in this Box NOTE: This SubWoofer can only be used with the ebode wireless LightSpeaker transmitter. It cannot be used or operated without the LightSpeaker transmitter. Installation Considerations Your ebode Wireless SubWoofer can be placed in any area or zone where you would like additional bass to your existing LightSpeaker distributed audio system. The only wiring required is to plug it into a standard electrical outlet. a) Your ebode Wireless SubWoofer is set up and ready to play. Play a favourite piece of music, ideally one with a lot of bass to ensure it's functioning properly. B) With one person at the listening position or some convenient position not too close to the subwoofer (2 to 3 meter back is fine) and the other person operating the phase, switch on the back of the SubWoofer. C) While listening to the deepest bass notes in the music, flip the phase switch back and forth while the listener determines which setting produces the most bass. Leave the switch in the position with the most bass. D) Keep in mind there is no wrong position for this switch, and if you can't reliably hear a difference in either position then it will not matter which position the switch is left at. step 6: Setting the Crossover Frequency. There are three possible crossover frequencies to choose from: 80Hz, 100Hz and 120Hz. The one you choose will depend on where your SubWoofer is located and your personal taste. Remember, if you find one setting you like better than another, then leave it at the setting you like best. The closer your ebode Wireless SubWoofer is to the corner, the LOWER the crossover will be set. [. . . ] There are no other warranties, including without limitation, either express or implied warranties of merchantability or fitness for a particular purpose, with respect to the product. repair or replacement as provided under this warranty is the exclusive remedy of the consumer/purchaser. Ebode electronics shall not be responsible for any incidental or consequential damages except to the extent provided (or prohibited) by applicable law. Some COUNTRIES do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. [. . . ]