User manual EDOBE XDOM TAKE 6 IR/RF

[. . . ] General Security Note Attention: For carefree and safe use of this product, please read this manual and safety information carefully and follow the instructions. Technical manipulation of the product or any changes to the product are forbidden, due to security and approval issues. Please take care to set up the device correctly - consult your user guide. Children should use the device only under adult supervision. [. . . ] If you step past the correct code use CHAN- (6) to go back to the right code. When the equipment you want to control reacts, press -/-- (13) to confirm the code. Note: If your equipment doesn't have CHAN+ you can use PLAY (DVR or DVD) (15) or POWER (1) key. You can only learn the codes for one original remote control per mode, e. A TV with built-in DVD player) you first have to learn the TV functions in TV mode and then the DVD functions in DVD mode. Keep a distance of 2, 5 cm between the remote controls. Press the button on the TAKE 6 remote you want to store the new command under. Depending on the type of remote control you have, you can use one of two methods: a. press the button on the existing remote control you want to learn. Keep this button pressed until the LED on the TAKE 6 Remote extinguishes. If the LED does not extinguish, but starts flashing, you need to use method B. (If youhave just tried method A and want to try method B, first repeat step 5). Keep this button pressed as long as you would when using the original remote control. Repeat steps 5 and 6 for every button you want to learn. When you have finished learning the buttons, press SETUP (8) Erasing the commands learned per mode to clear memory space You can erase the commands learned and saved for each separate function (TV, VCR, etc. Keep the SETUP (8) button pressed until the LED stays lit. The LED will extinguish after a few seconds. All commands learned and saved for the selected function have now been erased. Identifying codes found If you don't know the code (for example because you found the code by autosearch) you can identify it as described below: 1. Press and hold S (8) until the LED indicator (2) lights steadily. Press the mode key (4) for the equipment you want to identify (DVR, DVD, STB, AUDIO or AUX). To identify the first digit press each number button from 0 - 9 (14) until the LED blinks. [. . . ] As the TAKE10 features RF control, you can even control equipment which is out of sight - even through doors, walls and ceilings. If you have always wanted to distribute audio and video to a second room but have avoided doing so because of the cost and difficulties surrounding running cables, the easy answer has arrived. With this new product you avoid the interference from 2. 8 GHz Video Sender is designed to transmit audio and video signals without running any wires. [. . . ]