User manual EFD ULTRASAVER

[. . . ] If appropriate, connect ULTRASAVER to filter regulator. Press air hose firmly into fittings to connect. Set plant air supply (or filter regulator) within 80 to 100 psi (5. 4 to 7. 0 bar). [. . . ] (Do not contact the blue barrier to the fluid. ) LV BarrierTM Thick or non-leveling materials Same procedure as with thin, pourable fluids EXCEPT: Spoon fluid into the barrel with a spatula. (If packed in a 1/10 gallon cartridge, try loading the barrel with a caulking gun. ) Note: Move the fluid toward the bottom of the barrel by pressing the SmoothFlowTM piston. Squeeze barrel sides slightly to allow trapped air to escape. Caulking gun or spatula Air gap 2/3 max. Set air pressure to 30 psi 30 30 THIN fluid settings 1. If drop forms at tip, turn vacuum control counter-clockwise until drop disappears. 5 2. Set time at #3 5 5 5 3 5 2. To fill tip, set mode switch to steady (yellow light on) and press foot pedal. If dots are required, reset mode switch to green. Set time at #3, adjust as necessary. Note: Settings are general recommendations. For best results, test settings for your specific application. How to make DOTS GREEN Time range adjustments ­ special setups Most applications work best with ULTRASAVER's default time setting (shipped with 0. 010 ­ 1. 000 momentary). However, for special setups the ULTRASAVER's time range may be adjusted with the rotary switch located under the plug in the bottom panel of the cabinet. To change the time range, rotate the switch to the desired setting using a small screwdriver. In maintained mode, the foot pedal must remain depressed throughout the entire dispense cycle. Releasing the pedal during a cycle will interrupt the cycle. In momentary mode, the foot pedal can be pressed and immediately released, and the cycle will continue. If the pedal is pressed again during a cycle, the dispenser will stop. Press the mode switch so the green light is lit. [. . . ] This warranty is valid only when clean, dry, filtered air is used. EFD makes no warranty whatsoever of merchantability or fitness for a particular purpose. In no event shall EFD be liable for incidental or consequential damages. Headquarters: 977 Waterman Avenue, East Providence, RI 02914-1342 USA USA: 800-556-3484 Mexico: 001-800-556-3484 Telephone: 401-434-1680 Fax: 401-431-0237 e-mail: ultrasaver@efd-inc. com www. efd-inc. com Unit 14, Apex Business Centre, Boscombe Road Dunstable, Bedfordshire LU5 4SB UK Telephone: 01582 666334 Fax: 01582 664227 Freephone: 0800 585733 From Ireland: 00800 8272 9444 This equipment is regulated by the European Union under WEEE Directive (2002/96/EC). [. . . ]