User manual EIKI LC-SM1

[. . . ] MULTIMEDIA PROJECTOR MODEL LC-SM1 OWNER'S MANUAL LC-SM1 TO THE OWNER Before operating this projector, read this manual thoroughly and operate the projector properly. This projector provides many convenient features and functions. Operating the projector properly enables you to manage those features and maintains it in better condition for a considerable time. Improper operation may result in not only shortening the product-life, but also malfunctions, fire hazard, or other accidents. [. . . ] (From 0 to 63. ) Contrast Press POINT LEFT button to decrease contrast, and press POINT RIGHT button to increase contrast. (From 0 to 63. ) Brightness Press POINT LEFT button to adjust the image darker, and press POINT RIGHT button to adjust brighter. (From 0 to 63. ) Gamma Press either POINT LEFT button or POINT RIGHT button to obtain better balance of contrast. (From 0 to 16. ) Each of the keys operates as follow. Reset Recalls the data previously adjusted. Stored Stores the adjusted data in the memory. Quit Closes the PICTURE IMAGE ADJUSTMENT Menu. NOTE: The Fine sync and the Total dots cannot be fully adjusted when "RGB, " "HDTV1O35i" or "HDTV1O8Oi" is selected on the SYSTEM MENU (P22 and 23). NORMAL FUNCTION The normal picture level is preset on this projector at the factory and can be restored anytime you press the NORMAL button (located on the Top Control or on the Remote Control Unit). The "Normal" display will be displayed on the screen for a few seconds. 26 COMPUTER MODE AUTO IMAGE FUNCTION The Auto Image function is provided to automatically adjust Fine sync, Total dots, and Picture Position for most computers. 1 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select AUTO IMAGE and press the SELECT button. Another dialog box AUTO IMAGE Menu will appear. Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN button. Change the setting On or Off by pressing the SELECT button. 2 Fine sync Adjust the picture as necessary to eliminate flicker from the display. (Refer to page 26. ) Total dots The number of the total dots in one horizontal period. (Refer to page 26. ) Position Adjustment of the position of the image. (Refer to page 27. ) 3 Move the arrow to "Go!" and press the SELECT button to start the Auto Image function. This adjustment can be executed by pressing AUTO IMAGE button on the Remote Control Unit. Closes the AUTO IMAGE FUNCTION Menu. Stored Go Quit NOTE: The Fine sync and the Total dots cannot be fully adjusted when "RGB, " "HDTV1O35i" or "HDTV1O8Oi" is selected on the SYSTEM MENU (P22 and 23). The Fine sync, Total dots, and Picture Position of some computers may not be fully adjusted with the Auto Image Function. In that case, manual adjustment is required to make fine image. (Refer to page 26 to adjust "Fine sync" or "Total dots" and page 27 to adjust Picture Position. ) PICTURE POSITION ADJUSTMENT The position of the image can be adjusted vertically and horizontally through PICTURE POSITION ADJUSTMENT. 1 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select POSITION and press the SELECT button. The PICTURE POSITION dialog box will appear. [. . . ] No image. No sound. · · · · · · 37 Problem: Remote Control Unit does not work · · · · · Try these Solution Check the batteries. Check the ALL-OFF switch on the Remote Control Unit is set to "ON. ". Make sure nothing is between the Remote Receiver and the Remote Control Unit. Make sure you are not too far from the projector when using the Remote Control Unit. [. . . ]