User manual EINHELL BG-BC 43

[. . . ] Vor Inbetriebnahme Bedienungsanleitung und Sicherheitshinweise lesen und beachten Read and follow the operating instructions and safety information before using for the first time. Safety Regulations Layout and items supplied Intended use Technical data Assembly Before starting the equipment Operation Cleaning, maintenance and ordering of spare parts Disposal and recycling Troubleshooting When using the equipment, a few safety precautions must be observed to avoid injuries and damage. Please read the complete operating instructions and safety regulations with due care. Keep this manual in a safe place, so that the information is available at all times. [. . . ] Once the engine has started, move the choke lever immediately to " " and allow the machine to warm up for approx. Please note: Since the throttle lever is secured, the cutting tool starts to operate when the engine is started. Then release the throttle lever by simply actuating it (the engine then returns to running in idle mode). If the engine does not start up, repeat steps 6-7 above. Please note: If the engine does not start up even after several attempts, read the section "Engine Troubleshooting". Please note: Always pull the starter cord out in a straight line. If it is pulled out at an angle, then friction will occur on the eyelet. As a result of this friction, the cable will become frayed and will wear away faster. Always hold the starter handle when the cable retracts. Never allow the cable to snap back when it has been pulled out. PLEASE NOTE: Even if it is used carefully, cutting around foundations, stone or concrete walls, etc. Will result in the line suffering more than normal wear. tRIMMING / MOWING Swing the trimmer from side to side in a scything motion. Always keep the cutting head parallel to the ground. Check the site and decide what cutting height you require. Guide and hold the cutting head at the required height to ensure that you cut evenly (Fig. LOWER TRIMMING Hold the trimmer right in front of you at a slight angle so that the underside of the cutter head is above the ground and the line strikes the correct target. Never draw the trimmer towards yourself. CUTTING ALONG FENCES / FOUNDATIONS When cutting approach wire mesh fences, lath fences, natural stone walls and foundations slowly so that you can cut close to them without striking the obstacle with the line. If, for example, the line strikes stones, stone walls or foundations, it will wear or fray. if the line strikes wire fencing it will break. TRIMMING AROUND TREES When trimming around tree trunks, approach slowly so that the line does not strike the bark. [. . . ] Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. We do not charge you for this guarantee. [. . . ]