User manual EINHELL BG-GP 736

[. . . ] The operator is responsible for complying with local safety and installation regulations. (Ask an electrician if you are in any doubt. ) Consequential damage caused by flooded rooms in the event of the equipment suffering faults must be prevented by the user by means of suitable measures (for example installing alarm systems or a reserve pump, etc. In the event of a failure, repair work may only be carried out by an electrician or by ISC after sales service personnel. [. . . ] Position the intake line so that it rises from the water withdrawal point to the equipment. Avoid positioning the suction pipe higher than the pump, as this would delay the escape of air bubbles from the suction pipe and impede the priming process. Install the intake and discharge lines in such a way that they do not exert any mechanical pressure on the equipment. The intake valve should be low enough in the water to ensure that if the water level falls, the equipment will not run dry. A leaking intake line will draw in air and therefore not draw in any water. If necessary, install a prefilter for this purpose. 2 Connecting the discharge line The discharge line (min. 3/4") must be connected to the 1" female thread discharge line connector of the equipment either directly or with the aid of a threaded nipple. With the right couplings it is also possible, of course, to use a 1/2" delivery hose. the smaller delivery hose results in a lower delivery rate. During the priming operation, fully open any shut-off mechanisms (spray nozzles, valves, etc. ) in the pressure line so that the air can escape without obstruction. Off automatically by the thermostat if overheating occurs and is switched on again automatically after cooling. 2 Storage If the pump is not going to be used for a long time or has to be removed for the winter months, rinse it out with water, empty it completely and allow it to dry. The equipment must be completely drained before it is subjected to frost. After long stoppages, make sure the rotor turns correctly by briefly switching the pump on and off. 3 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. Fill the pump housing with water via the water filler screw (4). The intake process starts automatically; water can be suctioned in for up to 5 minutes (maximum suction height). If the pump is removed again after use, it must always be refilled with water whenever it is connected up and used again. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. The unit is supplied in packaging to prevent its being damaged in transit. [. . . ] Damage caused by the device being dropped) and normal wear resulting from proper operation of the device. The guarantee is rendered null and void if any attempt is made to tamper with the device. The guarantee is valid for a period of 2 years starting from the purchase date of the device. Guarantee claims should be submitted before the end of the guarantee period within two weeks of the defect being noticed. [. . . ]