User manual EINHELL BG-PW 18

[. . . ] The machine must not be used to transport inflammable, gassing, explosive and aggressive fluids (such as petrol, acids, lyes, silo percolating juice, etc. ) and fluids that contain abrasive substances (such as sand). The machine is to be used only for its prescribed purpose. Any other use is deemed to be a case of misuse. [. . . ] Insert fresh engine oil up to the top mark on the oil dipstick (Figure 8 / Item H). Only inset the oil dipstick to check the oil level. While the machine is working, the oil level must be between the two marks "L" and "H" (Figure 8). Remove the air filter cover (Figure 9-10) Remove the filter insert (Figure 11) Clean the air filter by tapping it, blowing it out with compressed air or by washing it with soap suds. Leave the air filter to dry before you refit it. Remove the spark plug boot by twisting it (Figure 12) Remove the spark plug using a spark plug wrench (Figure 13) Clean the spark plug with a copper wire brush or fit a new one. 4 Fuel filter Remove the fuel line (Figure 14) Unscrew the fuel filter from the tank (Figure 15) Clean the fuel filter with compressed air. Ensure that you do not damage the filter. 3 Storage Rinse the pump thoroughly with water before lengthy periods of inactivity or winter storage. Close the petrol cock and allow the engine to run until it stops to empty the carburetor. Store the machine in a dry place out of the reach of children. Disconnect the spark plug boot before doing any cleaning and maintenance work!1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. 2 Maintenance In this connection, please also read the attached service information 7. 1 Changing the oil The engine oil is best changed when the engine is at working temperature Use only engine oil (10W40). Place the machine on a slightly inclined surface so that the oil drain plug is at the lower end (Figure 7 / Item A). Remove the oil filler screw (Figure 7 / Item B). [. . . ] no guarantee claims will be accepted after the end of the guarantee period. The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. [. . . ]